Epson Pro EX11000 Notices and Warranty

Supplier’s Declaration of Conformity

According to 47CFR, Part 2 and 15 for Class B Personal Computers and Peripherals; and/or CPU Boards

and Power Supplies used with Class B Personal Computers:

We: Epson America, Inc.

Located at: 3131 Katella Ave., Los Alamitos, CA 90720

Telephone: (562) 981-3840

Declare under sole responsibility that the product identified herein, complies with 47CFR Part 2 and 15 of

the FCC rules as a Class B digital device. Each product marketed, is identical to the representative unit

tested and found to be compliant with the standards. Records maintained continue to reflect the

equipment being produced can be expected to be within the variation accepted, due to quantity

production and testing on a statistical basis as required by 47CFR § 2.906. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

Trade Name: Epson

®

Type of Product: LCD Projector

Model: HA72A

Marketing Name: EX11000

Options: Remote controller (model 2221508 xx [x=0-9])

Wireless Product Safety Instructions

Contains WLAN/BT module model: WLU5630B-D101 (RoHS)

This document provides safety instructions and describes the specifications. Read this document carefully

before use to ensure your safety and product performance. This device is restricted to indoor operation

only. Data transmission is always initiated by software, which is then passed down through the MAC,

through the digital and analog baseband, and finally to the RF chip. Several special packets are initiated by

the MAC. These are the only ways the digital baseband portion will turn on the RF transmitter, which it

then turns off at the end of the packet. Therefore, the transmitter will be on only while one of the

aforementioned packets is being transmitted. In other words, this device automatically discontinues

transmission in case of either absence of information to transmit or operational failure.

U.S.

Contains FCC ID: BKMAE-WLU5630

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

•

Consult the dealer or an experienced radio/TV technician for help.