Epson TrueOrder KDS Epson TrueOrder KDS Network Settings - Quick User Manual
Epson TrueOrder KDS Manual
 |
View all Epson TrueOrder KDS manuals
Add to My Manuals
Save this manual to your list of manuals |
Epson TrueOrder KDS manual content summary:
- Epson TrueOrder KDS | Epson TrueOrder KDS Network Settings - Quick User Manual - Page 1
, allowing them to be easily added and discovered on the local network. It may be necessary to configure the devices to a static IP and this guide explains how to do that from the Configurator. While the IP can be referenced from the configurator, it is also conveniently displayed on the KDS - Epson TrueOrder KDS | Epson TrueOrder KDS Network Settings - Quick User Manual - Page 2
assumes that you already have a Single or Multi-Station system setup as described in the Epson KDS Quick Start Guides. Open IP Settings window for a device. 1. Click STATIONS 2. Select DEVICE CONFIG 3. Click for the device to change IP Settings 4. Click Edit IP Settings Network Settings - Epson TrueOrder KDS | Epson TrueOrder KDS Network Settings - Quick User Manual - Page 3
to verify the new IP address. Repeat the steps for all of the devices in the system you wish to configure. Network Settings Quick User Manual 111-56-QUM-022 Rev 3.00
-
1 -
2 -
3
 |
 |
111-56-QUM-022
Rev 3.00
EPSON is a registered trademark and EPSON is a registered logomark of Seiko Epson Corporation. All other product and brand
names are trademarks and/or registered trademarks of their respective companies. Epson disclaims any and all rights in these marks.
Copyright 2023 Seiko Epson Corporation.
Network Settings
About this guide:
This guide consists of 2 sections:
•
Overview
–
Description of what this is in an Epson True Order Kitchen
Display System (KDS).
•
How to Configure
–
A procedure that can be followed to configure this in
a KDS system.
Overview
By default TrueOrder KDS devices are DHCP enabled, allowing them to be
easily added and discovered on the local network. It may be necessary to
configure the devices to a static IP and this guide explains how to do that from
the Configurator. While the IP can be referenced from the configurator, it is also
conveniently displayed on the KDS splash screen. The splash screen is
displayed during power up and can also be displayed by pressing the logo on the
header bar for a touch screen or by pressing the Summary key 3 times using a
bump bar.