Frigidaire FFRE0533S1 Installation Instructions

Frigidaire FFRE0533S1 Manual

Get Frigidaire FFRE0533S1 PDF manuals and user guides View all Frigidaire FFRE0533S1 manuals
Add to My Manuals
Save this manual to your list of manuals

Frigidaire FFRE0533S1 manual content summary:

  • Frigidaire FFRE0533S1 | Installation Instructions - Page 1
    Installation Instructions READ BEFORE INSTALLING UNIT OPP Window Mounting (5,000~6,500 BTU) INSTALLATION WARNINGS AND CAUTION Carefully read the installation manual before beginning. Follow each step as shown. Observe all local, state, and national electrical codes and by qualified, licensed,
  • Frigidaire FFRE0533S1 | Installation Instructions - Page 2
    330 mm Wooden Windows INNER WINDOW SILL 13Ǝ min 330 mm Vinyl-Clad Windows Storm Window: If the air conditoner is blocked by Storm Window, add wood as shown in FIG. 5, or remove storm window before air conditioner is installed. If Storm Window Frame must remain, be sure the drain holes or slots
  • Frigidaire FFRE0533S1 | Installation Instructions - Page 3
    How to Install Installation Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air conditioner frame is against the window sill (FIG. 6A & FIG. 6B). Carefully close the window behind the top rail of the unit. FIG. 6A FIG. 6B INSIDE
  • Frigidaire FFRE0533S1 | Installation Instructions - Page 4
    Installation again, until the insulation panel fits the frame, as shown (FIG.12). Repeat these instructions for the other side. FIG. 10 1 2 3 4 5 6 1 2 to lock the windows with the sash lock for Vinyl-Clad windows, so you can use lock by window itself. 9 Cut foam window seal and insert
  • Frigidaire FFRE0533S1 | Installation Instructions - Page 5
    by the arrows in Fig. 16. Vinyl-Clad Window FIG. 16 Removing the air conditioner From Window Turn the air conditioner off, and disconnect power cord. Remove sash seal from between windows, and unscrew sash lock. Remove screws installed through frame and framelock. Remove the insulation panel and
  • 1
  • 2
  • 3
  • 4
  • 5
READ BEFORE INSTALLING UNIT
OPP Window Mounting (5,000~6,500 BTU)
1
Installation Instructions
Before installing, the top rail must be assembled on the unit.
Top Rail Hardware
Qty.
4
1
3/8
Ǝ
Screw
Top Rail
Some assembly is required. Please read these instructions
carefully.
DO NOT USE ANY SCREWS OTHER THAN
THOSE SPECIFIED HERE.
NOTE:
SAVE CARTON and these INSTALLATION
INSTRUCTIONS for future reference. The carton is
the best way to store unit during winter, or when not
in use.
FOR SAFETY REASONS, THE TOP RAIL MUST BE
SECURELY FASTENED WITH ALL FOUR (4)
SCREWS.
A. Remove the air conditioner from the carton and place on a flat surface.
B. Remove top rail from the rear of the packaging material as shown in Fig. A
C. Align the hole in the top rail with those on the top of the unit as shown in Fig. B
D. Secure the top rail to the unit with the 3/8
Ǝ
Screws as shown in Fig. C
Fig. B
Packaging
Top Rail
Fig. A
16120300A04631
Fig. C
Pay attention to danger and safety notices.
To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may
be exposed:
Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install
the unit. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp metal fins of front and rear coils. To
prevent injury or strain, use proper lifting and carrying techniques when moving unit.
Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit overan extended
period of time.
Handle air conditioner with care.
Make sure air conditioner does not fall during installation.
Carefully read the installation manual before beginning.
Follow each step as shown.
Observe all local, state, and national electrical codes and by qualified, licensed, authorized personnel only.
INSTALLATION WARNINGS AND CAUTION
Drill (If pilot holes are needed)
7
1
Mounting Hardware
Qty.
2
s)
2
(
or Wooden windows)
weather stripping
insulation panel
ruler
(10”X3/4”X1/12”)
5
window sash seal foam
1
2
1