Frigidaire FFRL0633Q1 Installation Instructions

Frigidaire FFRL0633Q1 Manual

Get Frigidaire FFRL0633Q1 PDF manuals and user guides View all Frigidaire FFRL0633Q1 manuals
Add to My Manuals
Save this manual to your list of manuals

Frigidaire FFRL0633Q1 manual content summary:

  • Frigidaire FFRL0633Q1 | Installation Instructions - Page 1
    Installation Instructions READ BEFORE INSTALLING UNIT For Low Profile Window Air Conditioner INSTALLATION WARNINGS AND CAUTION Carefully read the installation manual before beginning. Follow each step as shown. Observe all local, state, and national electrical codes and by qualified, licensed,
  • Frigidaire FFRL0633Q1 | Installation Instructions - Page 2
    D. Slide the panel all the way in and repeat on the other side. FIG.1 "I" section FIG.2 FIG.3 Top Rail Your air conditioner is designed to install in standard double hung windows with opening widths of 26.5 to 41.5 inches (673 mm to 1054 mm) (FIG. 4)̻ Fig. 4 Lower sash must open sufficiently
  • Frigidaire FFRL0633Q1 | Installation Instructions - Page 3
    injury. 5 Install the air conditioner in the window window sash With the aid of an assistant, carefully lift the air conditioner and slide it into the open window. Make sure that support bracket is inserted in the pocket top channel under base fan, and that filler panels guide is stopped by
  • Frigidaire FFRL0633Q1 | Installation Instructions - Page 4
    installed as instructed to avoid the possibility of unit falling from window and causing personal injury or property damage. 8 IF AIR CONDITIONER IS BLOCKED BY STORM WINDOW storm window frame is located on outer sill 9 INSTALLATION FOR OTHER TYPE WINDOWS: Dimensions and geometry of windows are
  • Frigidaire FFRL0633Q1 | Installation Instructions - Page 5
    being spilled out on floor. Always store unit flat on its base. Remove bracket and window sash seal from window and save. Window can not close if support bracket remains installed. Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and
  • 1
  • 2
  • 3
  • 4
  • 5
READ BEFORE INSTALLING UNIT
For Low Profile Window Air Conditioner
1
Installation Instructions
DO NOT USE ANY SCREWS OTHER THAN THOSE SPECIFIED IN THESE INSTRUCTIONS.
NOTE:
SAVE CARTON and these INSTALLATION INSTRUCTIONS for future reference. The carton is the best way to
store unit during winter, or when not in use.
Tools
Required
RULER
HAMMER
KNIFE
PENCIL
LEVEL
SCREWDRIVER (Standard and Phillips and Flathead)
Hardware ( in plastic bag)
Qty.
1
1
SUPPORT BRACKET
Qty.
1
LONG LEVELING BOLT
1
1
Hardware ( in plastic bag)
8
SHORT LEVELING BOLT
SASH LOCK
WINDOW SASH SEAL
FOAM STRIP
1
WEATHER SEALS
5
2020211A2565
Pay attention to danger and safety notices.
To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may
be exposed:
Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install
the unit. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp metal fins of front and rear coils. To
prevent injury or strain, use proper lifting and carrying techniques when moving unit.
Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit overan extended
period of time.
Handle air conditioner with care.
Make sure air conditioner does not fall during installation.
Carefully read the installation manual before beginning.
Follow each step as shown.
Observe all local, state, and national electrical codes and by qualified, licensed, authorized personnel only.
INSTALLATION WARNINGS AND CAUTION