Frigidaire FRA123CT1 Installation Instructions (All Languages)

Frigidaire FRA123CT1 Manual

Get Frigidaire FRA123CT1 PDF manuals and user guides
UPC - 012505273735
View all Frigidaire FRA123CT1 manuals
Add to My Manuals
Save this manual to your list of manuals

Frigidaire FRA123CT1 manual content summary:

  • Frigidaire FRA123CT1 | Installation Instructions (All Languages) - Page 1
    Installation Instructions READ BEFORE INSTALLING UNIT Compact Window Mounting (10~12K BTU) To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may be exposed: Air conditioners covered in this manual pose an excessive weight
  • Frigidaire FRA123CT1 | Installation Instructions (All Languages) - Page 2
    D. Slide the panel all the way in and repeat on the other side. FIG. 1 FIG. 2 "I" section FIG. 3 Top Rail Bottom Rail Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches (584 mm to 914 mm) (FIG. 4A ̹ FIG. 4B)̻ Lower sash must open
  • Frigidaire FRA123CT1 | Installation Instructions (All Languages) - Page 3
    How to Install Installation Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air conditioner frame is against the window sill (FIG. 6A & FIG. 6B). Carefully close the window behind the top rail of the unit. FIG. 6A FIG. 6B INSIDE
  • Frigidaire FRA123CT1 | Installation Instructions (All Languages) - Page 4
    sash lock. Remove screws installed through frame and framelock. Close (slide) side panels into frame. Keeping a firm grip on air conditioner, raise sash and carefully remove. Be careful not to spill any condensate water while lifting unit from window. Store parts WITH air conditioner. 4 ),*
  • 1
  • 2
  • 3
  • 4
READ BEFORE INSTALLING UNIT
Compact Window Mounting (10~12K BTU)
1
Installation Instructions
Before installing, the top rail must be assembled on the unit.
Top Rail Hardware
Qty.
4
1
Top Rail
The top rail on your unit may already be installed. If not,
follow the steps below.
To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp
edges that may be exposed:
Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to
move and install the unit. To prevent injury or strain, use proper lifting and carrying techniques when moving unit.
Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit over
an extended period of time.
Handle air conditioner with care. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp
metal fins on front and rear coils.
Make sure air conditioner does not fall during installation.
Drill (If pilot holes are needed)
7
sash lock
1
Mounting Hardware
Qty.
2
lock frame
(For Vinyl-Clad windows)
NOTE:
the best way to store unit during winter, or when not
in use.
2
lock frame
(For Wooden windows)
A. Remove the air conditioner from the carton and place on a flat surface.
B. Remove top rail from the rear of the packaging material as shown in Fig. A
C. Align the hole in the top rail with those on the top of the unit as shown in Fig. B
Fig. B
2020215A0329
Fig. C
weather seals
5
window sash seal foam
1
Packaging
Top Rail
Fig. A