Frigidaire FRA12EZU2 Installation Instructions (All Languages)
Frigidaire FRA12EZU2 Manual
 |
UPC - 012505275494
View all Frigidaire FRA12EZU2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Frigidaire FRA12EZU2 manual content summary:
- Frigidaire FRA12EZU2 | Installation Instructions (All Languages) - Page 1
Installation Instructions READ BEFORE INSTALLING UNIT For SLO3 Air Conditoner (8,000~12,000 BTU) INSTALLATION WARNINGS AND CAUTION Carefully read the installation manual before beginning. Follow each step as shown. Observe all local, state, and national electrical codes and by qualified, licensed, - Frigidaire FRA12EZU2 | Installation Instructions (All Languages) - Page 2
outlet within 4 ft (122 cm) of where the power cord exits the air conditioner. Free movement of air in room to be cooled. A large enough opening for the air conditioner. Adequate wall support for weight of air conditioner. Air conditioner weights between 70 and 85 Ibs (32 to 40 kgs). NOTE: Do not - Frigidaire FRA12EZU2 | Installation Instructions (All Languages) - Page 3
Instructions FIG.3A FIG.3B FIG.4 FIG.5 B A A. shipping screw B B. front panel screw electronics plug C C. handle NOTE: Handle the air conditioner gently. Be sure your air conditioner RQWKH air conditioner (FIG.7B, FIG.7C). 4. Slide the curtain housing into the curtain guides as far as - Frigidaire FRA12EZU2 | Installation Instructions (All Languages) - Page 4
WRVRWKDWZDWHUFRXOGUXQWRWKHRXWVLGH 6HH),* FIG.11 % $ FIG.12 % FIG.13 :LQGRZ6DVK C $ $$ SDQKHDG side curtains out against the window frame (FIG.11). $ ),*$ $ ),*% 2. Drill holes and drive locking screws: A: For wooden windows: 8VHDƎGULOOELWWR - Frigidaire FRA12EZU2 | Installation Instructions (All Languages) - Page 5
-head screws to secure window in place (FIG.15). 5. Insert air conditioner into cabinet (FIG.16). 6. Reconnect electronics plug if present. Insert front . See FIG.20 for dimensions. 2. Measure the outside width and height of frame to determine wall opening dimensions. The wall opening measurements - Frigidaire FRA12EZU2 | Installation Instructions (All Languages) - Page 6
Installation Instructions NOTE: FIG.21 A Dimension for depth depends on wall thickness and type of molding B (FIG.21). Do not block louvers in air conditioner cabinet. 8VHƎ FP RUWKLFNHUOXPEHUIRUZRRGIUDPH C A. Outside width C. Depth B. Outside height Install Cabinet into Wood
-
1 -
2 -
3 -
4 -
5 -
6
 |
 |
READ BEFORE INSTALLING UNIT
For SLO3 Air Conditoner (8,000~12,000 BTU)
1
Installation Instructions
Tools and Parts:
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools
listed here.
Flat-blade and Phillips screwdrivers
Level
TOOLS NEEDED
Tape measure
,
Through-the-wall Installation:
In addition to the tools listed above, the following tools are needed for through-the-wall installation.
saw
caulk
TOOLS NEEDED
Parts Supplied:
Check that all parts are included in parts package:
Hardware
Qty.
3
pan - head
Phillips screws
Qty.
1
1
round - head
screws
pan - head
Phillips screws
Top channel
Window sash seal
window lock bracket
Hardware
1
Foam seal
1
side curtains
2
2
Safety Lock
(for Vinyl-Clad window)
weather seals
Pay attention to danger and safety notices.
To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may
be exposed:
Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install
the unit. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp metal fins of front and rear coils. To
prevent injury or strain, use proper lifting and carrying techniques when moving unit.
Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit overan extended
period of time.
Handle air conditioner with care.
Make sure air conditioner does not fall during installation.
Carefully read the installation manual before beginning.
Follow each step as shown.
Observe all local, state, and national electrical codes and by qualified, licensed, authorized personnel only.
INSTALLATION WARNINGS AND CAUTION