Frigidaire GAC102P1A Installation Instructions
Frigidaire GAC102P1A - GIBSON 10000BTU 115V 9.2A 9.8E3 SPD 8 WAY AIR DIRECTION1 Manual
 |
UPC - 012505272370
View all Frigidaire GAC102P1A manuals
Add to My Manuals
Save this manual to your list of manuals |
Frigidaire GAC102P1A manual content summary:
- Frigidaire GAC102P1A | Installation Instructions - Page 1
Installation Instructions READ BEFORE INSTALLING UNIT Compact II Window Mounting Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches (584 mm to 914 mm) (FIG. 1) Lower sash must open sufficiently to - Frigidaire GAC102P1A | Installation Instructions - Page 2
one hand and gently pull back the center to free the open end. See Figure 2. FIG. 2 FIG. 4 C. Once the panel has been FIG. 5 installed Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air conditioner frame is against the window sill - Frigidaire GAC102P1A | Installation Instructions - Page 3
remove storm window before air conditioner is installed. FIG. 14 SASH air conditioner, raise sash and carefully "rock" air conditioner backward to drain any condensate water in base of unit. Be careful not to spill any remaining water while lifting unit from window. Store parts WITH air conditioner
-
1 -
2 -
3
 |
 |
1
Installation Instructions
READ BEFORE INSTALLING UNIT
Compact II Window Mounting
Your air conditioner is designed to install in standard
double hung windows with opening widths of 2
3
to 36
inches (5
84
mm to 914 mm) (FIG. 1)
Lower sash must open sufficiently to allow a clear vertical
opening of 14-1/2 inches (368 mm).
Side louvers and the
rear of the AC must have clear air space to allow
enough airflow through the condenser, for heat removal.
The rear of the unit must be outdoors, not inside a
building or garage.
TOOLS NEEDED:
Phillips Screw Driver
Drill (If pilot holes are needed)
Qty.
3/4"screws
7
lock frame
2
sash lock
1
Mounting Hardware
When handling unit, be careful to avoid cuts
from sharp metal edges and aluminum fins on
front and rear coils.
NOTE:
SAVE CARTON and these INSTALLATION
INSTRUCTIONS for future reference. The carton is the
best way to store unit during winter, or when not in use.
Some assembly is required. Please read these instructions
carefully.
CAUTION
Fig. A
Fig. B
Fig. C
Fig. E
Fig. F
Fig. G
Fig. D
Before installing the unit, the
Left-Hand
Louver must be assembled to the unit:
A.
Carefully remove power supply
cord from air discharge area
(Fig. A).
B.
Carefully remove the Left-Hand
Louver Assembly from the
discharge area, and then remove
it from the plastic bag(Fig. B).
C.
With care, pry apart the auger
wheel shaft from the horizontal
louver casing, as shown in Fig.
C, D & E.
D.
Now locate the auger wheel
shaft into the vertical center
post (Fig. F).
E.
Clip the other end into the
locating slot.
F.
Now place the horizontal louver
casing onto the auger wheel
shaft, and snap in place (Fig.
G).
G.
Check the operation by moving
the horizontal louver up and
down, and then turn the auger wheel so the vertical
louvers rotate.
SZ000357(En)
10/21/2004, 10:42 AM
1