Ganz Security ZN-NH11VNE Manual

Ganz Security ZN-NH11VNE Manual

Get Ganz Security ZN-NH11VNE PDF manuals and user guides View all Ganz Security ZN-NH11VNE manuals
Add to My Manuals
Save this manual to your list of manuals

Ganz Security ZN-NH11VNE manual content summary:

  • Ganz Security ZN-NH11VNE | Manual - Page 1
  • Ganz Security ZN-NH11VNE | Manual - Page 2
    Guide INFORMATION TO USER CAUTION RISK OF ELECTRIC SHOCK, ! DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING and maintenance (servicing) instructions in the literature accompanying the appliance. 2010/2-1 03A.02
  • Ganz Security ZN-NH11VNE | Manual - Page 3
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide Table of Contents 1. FEATURES ...5 2. PACKAGE CONTENTS 6 3. PART NAMES ...7 3.1. Rear View...7 3.2. Bottom 23 APPENDIX (C): DIMENSIONS 24 APPENDIX (D): ACCESSORIES APPENDIX (E): TROUBLE SHOOTING 25 Checking your Firmware...25 2010/2-1 03A.02 3
  • Ganz Security ZN-NH11VNE | Manual - Page 4
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide Support ...25 2010/2-1 03A.02 4
  • Ganz Security ZN-NH11VNE | Manual - Page 5
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide 1. FEATURES Camera  Box type IP Camera  Sony 1/3" Super HAD /resolution/bit rate and so on.)  De-interlacing on DSP  Burnt-in text supported  Unicast/Multicast supported Video/Audio  Video compression: H.264/MPEG/MJPEG, 25/30FPS@D1(PAL/NTSC) 
  • Ganz Security ZN-NH11VNE | Manual - Page 6
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide 2. PACKAGE CONTENTS Unpack carefully and handle the equipment protecting CCD) Hex wrench driver Adaptor for mounting the camera Screws Quick Installation Guide DC Jack Adaptor Cable i Note The above contents are subject to change without prior
  • Ganz Security ZN-NH11VNE | Manual - Page 7
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide 3. PART NAMES 3.1. Rear View ○1 ○2 ○3 ① LOOP OUT RESET RS-485 DO DI AUDIO ○4 ○5 ① - + C 1 C 1 Out In Micro SD ○6 ETHERNET ○7 ○8 3.2. Bottom View 2010/2-1 03A.02 ○9 7
  • Ganz Security ZN-NH11VNE | Manual - Page 8
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide ① Analog video out It is an analog video output port. ② Reset Reset switch is used for restarting ZN-Y11VE/ZN-NH11VE/ZN-NHW11VE or resetting
  • Ganz Security ZN-NH11VNE | Manual - Page 9
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide ⑧ 4 Pin connector for Auto IRIS Only DC-drive type is supported. Refer to the section "4.2. Installing an Auto IRIS lens" for more specific information. ⑨ Adaptor for mounting the camera Mounting points adaptor is provided on the
  • Ganz Security ZN-NH11VNE | Manual - Page 10
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide 4. INSTALLATION CCW CCWW SSeEtT SScCrReEwW (For IRIS LENS) 4.1. Installing a C/CS recommended by the manufacturer. For best performance, read the lens manual carefully. You may need to set the flange back focus. i Note Only DC-drive type is
  • Ganz Security ZN-NH11VNE | Manual - Page 11
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide 2 1 4 3 4 pin connector for IRIS PIN DC IRIS Lens 1 Damp- 2 Damp+ 3 Drive+_ 4 Drive- 4.3. Setting the . 4.4. Operating the OSD Menu To operate the OSD of camera, refer to the 'OSD Menu Control Manual' in the SDK. 2010/2-1 03A.02 11
  • Ganz Security ZN-NH11VNE | Manual - Page 12
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide 5. CONNECTIONS Analog Video Out LAN Cable LOOP OUT RESET RS-485 DO DI AUDIO - + C 1 C 1 Out In Micro SD ETHERNET DC Jack Adaptor Cabl Power Adaptor 4
  • Ganz Security ZN-NH11VNE | Manual - Page 13
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide 5.1.Connectors ① 9 pin terminal block LOOP OUT RESET RS-485 DO DI AUDIO - + C 1 C 1 Out In Micro SD ETHERNET ② RS-485 The RS-485 serial port consists
  • Ganz Security ZN-NH11VNE | Manual - Page 14
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide Internal +5V Output of DI Sensor + - COM Relay Type ④ Alarm (DO) connection Only the relay type is supported. Relay Rating: Max 24VAC 500mA or 12VDC 1A ! Do not exceed the maximum relay rating. Caution Internal Output of DI 1 Sensor+ -
  • Ganz Security ZN-NH11VNE | Manual - Page 15
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide ⑥ Power Adaptor Connector (DC 12V) Power adaptor connector connects to DC Jack adapter cable. - + + - RED ! Make sure the polarity is correct. Incorrect connection may cause
  • Ganz Security ZN-NH11VNE | Manual - Page 16
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide 6. CONFIGURATION 6.1.Set up network environment The default IP address of your IP device is 192.168.XXX.XXX. You can find the available IP address
  • Ganz Security ZN-NH11VNE | Manual - Page 17
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide To use the ZNS-GIT IPAdminTool and view the live to this website on the Security Certificate Alert page. (The explanation and captured images at this manual are mainly on the basis of Internet Explorer 7.0) 4. Click pop-up blocked and install the
  • Ganz Security ZN-NH11VNE | Manual - Page 18
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide 5. Wait for a few seconds while the web page loads. The live video is displayed as below. 6. If the live video is not displayed and "Can
  • Ganz Security ZN-NH11VNE | Manual - Page 19
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide 6.2.2. View video using IP address View the live video on a web page using your IP device and its IP address. To have the correct IP
  • Ganz Security ZN-NH11VNE | Manual - Page 20
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide APPENDIX (A): SPECIFICATIONS Summary Camera Module 0.03Lux/F1.2(B/W) Not supported 52dB(x128) ON/AUTO OFF/LOW/MIDDLE/HIGH Selectable ATW/AWC/MANUAL (1,800° K~10,500° K) AUTO/ MANUAL AUTO/ (NTSC: X256~1/60sec~ MANUAL 1/120,000sec, (NTSC
  • Ganz Security ZN-NH11VNE | Manual - Page 21
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide Compression Format Number of Streams Resolution CIF, QCIF, QVGA 25/30 fps@D1 (PAL/NTSC) Supported (DSP) Supported Supported (DSP) Supported (DSP) 1 Loop Out (BNC connector) 1/1 channel G.711 1/1 channel Supported 10/100 Base-T TCP/IP, UDP/IP, HTTP,
  • Ganz Security ZN-NH11VNE | Manual - Page 22
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide VCA Presence (Included as Standard) High Performance Advanced Tracking Data and Events Burnt-in Annotation Stream or Analog video out (※Analog video out support can vary depending on the device model and hardware version and the firmware version)
  • Ganz Security ZN-NH11VNE | Manual - Page 23
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide APPENDIX (B): POWER OVER ETHERNET The Power over Ethernet( operation. The product continues to work without rebooting. Power classification The PoE Power Class supported by the IP device is Class 0. Class 0 Usage Default Minimum Power Levels
  • Ganz Security ZN-NH11VNE | Manual - Page 24
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide APPENDIX (C): DIMENSIONS 55 94. 2 91. 4 5 5 Top view LOOP OUT RESET RS-485 DO DI AUDIO - + C 1 C 1 Out In Micro SD ETHERNET Rear view Front view H.264 Network Camera Right side view 2010/2-1 03A.02 UNIT: mm 24
  • Ganz Security ZN-NH11VNE | Manual - Page 25
    ZC-Y11VE/ZN-NH11VE/ZN-NHW11VE Installation Guide APPENDIX (E): TROUBLE SHOOTING Checking your Firmware Firmware is software that determines the functionality of the device. One of your first actions when troubleshooting a problem should be to check the currently installed version. The latest version
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25