Garmin GSD 22 Installation Instructions
Garmin GSD 22 - GPS Receiver Remote Sonar Sensor Manual
 |
UPC - 753759049225
View all Garmin GSD 22 manuals
Add to My Manuals
Save this manual to your list of manuals |
Garmin GSD 22 manual content summary:
- Garmin GSD 22 | Installation Instructions - Page 1
GSD 22 Sounder installation instructions August 2009 Part Number 190-00579-00 Rev. D Printed in Taiwan - Garmin GSD 22 | Installation Instructions - Page 2
unit or software or offer a full refund of the purchase price at its sole discretion. SUCH REMEDY SHALL BE YOUR SOLE AND EXCLUSIVE REMEDY FOR ANY BREACH OF WARRANTY. To obtain warranty service, contact your local Garmin authorized dealer or call Garmin Product Support for shipping instructions and - Garmin GSD 22 | Installation Instructions - Page 3
Garmin dealer. • GSD 22 Sounder • 6 ft (0.30 m) Power/Data Cable • 6 ft (0.30 m) Marine Network Cable • 1 Field Install Marine Ethernet Connector • 1 Marine Grommet • GSD 22 Sounder Installation Instructions Transducers A transducer is required to send and receive the sonar signal from the GSD 22 - Garmin GSD 22 | Installation Instructions - Page 4
Wiring and Cables. 5. Connect the power/data and transducer cables to the connectors on the back of the GSD 22. 6. Refer to the Marine Network wiring diagrams on page 4 for connecting the GSD 22 to compatible Garmin devices. Note: You can extend the power wiring of the GSD 22 power/data cable - Garmin GSD 22 | Installation Instructions - Page 5
cable (see below). 6. Firmly push the grommet into the installation hole until it is seated. 7. Test the connection before applying marine sealant, as needed, to create a waterproof seal. Cable hole for the Power/Data, Garmin Marine Network, or GPS 17 Cable Split GSD 22 Installation Instructions - Garmin GSD 22 | Installation Instructions - Page 6
show the network connections; however, they do not show the power connections. Wire each device according to the appropriate installation instructions. Note: These diagrams show the Garmin Marine Network connections; however, they do not show NMEA 2000 or NMEA 0183 connections. GSD 22 Installation - Garmin GSD 22 | Installation Instructions - Page 7
for 0.5 second (slow blink) Solid Red (no blink) Red blinking, on for 1/10 second, off for 1/10 second (very fast blink) Status GSD 22 is servicing one directly-wired connection and the chartplotter is operating properly. You should see sonar data on the chartplotter. GSD 22 is powered on but is - Garmin GSD 22 | Installation Instructions - Page 8
For the latest free software updates (excluding map data) throughout the life of your Garmin products, visit the Garmin Web site at www.garmin.com. August 2009 © 2009 Garmin Ltd. or its subsidiaries Garmin International, Inc. 1200 East 151st Street, Olathe, Kansas 66062, USA Garmin (Europe) Ltd.
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
GSD 22
Sounder
installation instructions
August 2009
Part Number 190-00579-00 Rev. D
Printed in Taiwan