GE DDC4500TWH Quick Specs

For answers to your Monogram,

®

GE Profile

™

or

GE

®

appliance questions, visit our website at

geappliances.com or call GE Answer Center

®

service,

800.626.2000.

370405

Specification Revised 11/09

DDC4500T

GE

®

5.4 Cu. Ft. Large Capacity Modular Commercial Gas Dryer

Dimensions and Installation Information (in inches)

Exhaust Options:

Shipped with exhaust to the rear.

Gas model

offers 2-way venting: left, right, or rear.

Maximum recommended exhaust duct length is 15

feet of 4" rigid ducting with two 90° elbows and 4" a

dampered wall cap.

(See Installation Instructions.)

Requirements:

Gas

– 115 Volts, 60 Hertz single phase. An individual

branch circuit, properly grounded for a 3-prong

outlet, fused for 15- or 20-amp is required for each

dryer. Gas rate input, 22000 BTU/Hr. Maintains the

thermostatically controlled heat flow to dry clothes

gently. Longer cool down period on Permanent Press

cycle helps prevent heat-set wrinkles. Separate

thermostat controls lower temperatures for Knit cycle

drying. Factory equipped for natural gas. Tested

for LP gas. A conversion kit is required for LP gas.

Check installation instructions for correct kit number.

Have a qualified technician install the conversion kit.

Equipped with energy saving Glo-Bar ignition.

77

27

27

Gas Dryer

only

11-3/4

41-5/8

3-1/2

3/4

1-7/8

2-3/8

Note:

Dimensions and specifications shown here are correct at the time this sheet was printed. Before

proceeding with construction or rough-in, check installation instructions that came with your unit.

Specifications, dimensions and design are subject to change without notice.

Note:

Wall anchor chain provided for gas models only.

Front View

Rear View