GE DPSB620GCWW Dimensions

GE DPSB620GCWW Manual

GE DPSB620GCWW manual content summary:

  • GE DPSB620GCWW | Dimensions - Page 1
    or 20 amp circuit breaker or a time-delay fuse is required. Gas Dryer Electric Rating: 120V, 60Hz, 6A Gas (BTU/HR): 25,000. Factory instructions packed with your dryer. For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service
  • GE DPSB620GCWW | Dimensions - Page 2
    DPSB620GCCC/WW GE Profile™ Super 7.0 Cu. Ft. Capacity Gas Dryer For complete information, see installation instructions packed with your dryer. Special Installation Requirements Ducting Materials: For best performance, this dryer should be vented with 4" diameter all rigid metal exhaust duct. If
  • GE DPSB620GCWW | Dimensions - Page 3
    DPSB620GCCC/WW GE Profile™ Super 7.0 Cu. Ft. Capacity Gas Dryer Features and Benefits • Perfect Dry™ System - Quickly and evenly dries almost all types of fabrics • Dual-Thermistor Heat Management - Maintains constant, even heat for shorter dry times and better fabric care • Full Electronic
  • 1
  • 2
  • 3

For answers to your Monogram,
®
GE Profile
or
GE
®
appliance questions, visit our website at
ge.com or call GE Answer Center
®
service,
800.626.2000.
DPSB620GCCC/WW
GE Profile
Super 7.0 Cu. Ft. Capacity Gas Dryer
Listed by
Underwriters
Laboratories
Specification Revised 10/07
36
42
27
2
3-1/2
2-1/2
25-1/2*
Side View
Rear View
8-1/2
28-1/4
23-1/2
11-1/2
*24-1/2" from the edge of the side panel to the front.
25-1/2" from front to edge of endcaps.
Exhaust Options:
When viewed from the
front of the unit, exhaust 3-way via rear, left
and bottom. Dryer is shipped exhausted to
the rear. Alternate exhausting knockouts are
supplied. Left or bottom exhaust requires a
conversion kit.
Gas:
An individual properly-grounded
branch circuit, with a three-prong grounding-
type receptacle, protected by a 15 or 20
amp circuit breaker or a time-delay fuse is
required.
Gas Dryer Electric Rating:
120V, 60Hz, 6A
Gas (BTU/HR):
25,000. Factory-equipped for
natural gas. Tested for LP gas. LP gas supply
requires a conversion kit. Check installation
instructions for correct kit and have a
qualified gas technician install a conversion
kit. See dryer ducting information for proper
installation.
Note:
Dryer wall outlet must be located within
36" of service cord entry and accessible when
dryer is mounted in position.
Installation Information:
For complete
information, see installation instructions
packed with your dryer.
Dimensions and Installation Information (in inches)
270180