GE PS960BLTS Installation Instructions
GE PS960BLTS Manual
 |
View all GE PS960BLTS manuals
Add to My Manuals
Save this manual to your list of manuals |
GE PS960BLTS manual content summary:
- GE PS960BLTS | Installation Instructions - Page 1
to the appliance. Remove all packing parts from oven, racks, heating elements and drawer. Also, remove protective film and labels on the outer door, cooktop and control panel. 2 PREPARE THE OPENING (FOR INDOOR USE ONLY) See illustrations for all rough-in and spacing dimensions. The range may be - GE PS960BLTS | Installation Instructions - Page 2
frame. SINGLE OVEN DOUBLE OVEN Rating plate Rating plate 4 POWER CORD AND CONDUIT INSTALLATION A Remove wire cover (on the back of range) by removing screws using a 1/4" nut driver. You can access the terminal block by either removing a terminal block cover (on some models) or the wire - GE PS960BLTS | Installation Instructions - Page 3
/neutral) wire tip through the bottom center terminal block opening. On certain models, the wire will need to be inserted through the ground strap opening and block Ground screw Neutral terminal Ground plate (grounding to range) FOR CONDUIT INSTALLATION A. Loosen the 3 lower terminal screws on the - GE PS960BLTS | Installation Instructions - Page 4
to the anti-tip device properly. MODELS WITH STORAGE DRAWER A Plug in unit and slide into place. Pull drawer out until it stops. B Lift front of drawer until the stops clear the guide. Remove the drawer. Spirit level C Install the oven shelves in the oven and position the range where it will be - GE PS960BLTS | Installation Instructions - Page 5
Control Frontal ¿Preguntas? Llame a GE Appliances al 800.GE.CARES (800.432.2737) o o adulto pueden volcar la cocina y morir. • Instale el soporte anti-volcaduras sobre la pared o el piso provocar daños al electrodoméstico. Quite todas las partes de empaque del horno, bandejas, elementos calentadores y - GE PS960BLTS | Installation Instructions - Page 6
ENERGÍA Y DE PASACABLES A Quite la tapa del cable (en la parte trasera de la cocina) quitando tornillos mediante una llave de tuercas de 1/4". (ver Anillo de el paso siguiente si utiliza un conducto expulsión portacables), instale el alivio de tensión en el en el orificio. Introduzca el cable - GE PS960BLTS | Installation Instructions - Page 7
5 INSTALACIÓN DE TRES (3) ALAMBRES ADVERTENCIA El cable neutral o a tierra del cable de energía debe estar conectado a la terminal neutral ubicada en el centro del bloque terminal y la cinta de conexión a tierra debe conectar la terminal neutral a la placa de conexión a tierra. Los cables de energ - GE PS960BLTS | Installation Instructions - Page 8
para que la parte trasera de la estufa se encuentre a la misma altura del mostrador (Y). Y D Deslice la unidad en su lugar. E Instale los estantes del tamaño mínimo para el elemento de inducción (consulte el Manual del Propietario), encienda la superficie de cocción. Verifique que todos los
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
2
PREPARE THE OPENING (FOR INDOOR USE ONLY)
See illustrations for all rough-in and spacing dimensions. The range may be placed with 0”
clearance (flush) at the back wall and side walls of the cabinet.
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
•
IMPORTANT
—
Save these
instructions for local inspector’s use.
•
IMPORTANT
—
Observe all
governing codes and ordinances.
•
Note to Installer –
Be sure to leave these
instructions with Consumer.
•
Note to Consumer –
Keep these
instructions for future reference.
•
Skill level –
Installation of this appliance
requires basic mechanical skills and
advanced electrical skills.
•
Proper installation is the responsibility of the
installer.
•
Product failure due to improper installation
is not covered under Warranty.
Installation Instructions
Free-Standing and Front
Control Electric Ranges
Questions? Call 1.800.GE.CARES (1.800.432.2737) or visit www.GEAppliances.com
In Canada, call 1.800.561.3344 or visit www.GEAppliances.ca
MATERIALS YOU MAY NEED
TOOLS YOU WILL NEED
(UL Listed 40 AMP)
4-Wire Cord 4’ long OR
3-Wire Cord 4’ long
Squeeze Connector
(For Conduit
Installations Only)
Drill with 1/8” Bit
Safety Glasses
Adjustable Wrench
Level
Tin Snips
Tape Measure
Pliers
1/4” Nut Driver
1
REMOVE PACKAGING MATERIALS:
Failure to remove packaging
materials could result in damage to the appliance. Remove all packing parts from oven,
racks, heating elements and drawer. Also, remove protective film and labels on the outer
door, cooktop and control panel.
FOR YOUR SAFETY:
WARNING
Before beginning
the installation, switch power off at
service panel and lock the service
disconnecting means to prevent power
from being switched on accidentally.
When the service disconnecting
means cannot be locked, securely
fasten a prominent warning device,
such as a tag, to the service panel.
If you did not receive an anti-tip bracket with your
purchase, call 1.800.626.8774 to receive one at
no cost. (In Canada, call 1.800.561.3344.) For
installation instructions of the bracket,
visit: www.GEAppliances.com.
(In Canada, www.GEAppliances.ca.)
Anti-Tip Bracket
Kit Included
• A child or adult can tip the range and be killed.
• Install the anti-tip bracket to the wall or floor.
• Engage the range to the anti-tip bracket by sliding the
range back such that the foot is engaged.
• Re-engage the anti-tip bracket if the range is moved.
• Failure to do so can result in death or serious burns
to children or adults.
Tip-Over Hazard
WARNING
2
1
2
” (3
1
4
” on
double ovens)
2
1
2
” (3
1
4
” on
double ovens)
(7
3
4
” on
double
ovens)
6
1
2
”
25”
(23” on
double
ovens)
REAR CONTROL
FRONT CONTROL
NOTE:
Use a 4’ power cord to prevent interference
with the storage drawer. Power cords 4
1
2
’ to 6’ long
may have to be dressed to allow for proper drawer
closing.
MINIMUM DIMENSIONS BETWEEN COOKTOP,
WALLS AND ABOVE THE COOKTOP:
A.
Make sure the wall covering, countertop, flooring
and cabinets around the range can withstand
the heat (up to 200°F) generated by the range.
B.
Allow 30” minimum clearance between surface
units and bottom of unprotected wood or metal
cabinet, or allow a 24” minimum when bottom
of wood or metal cabinet is protected by no
less than 1/4” thick flame retardant millboard
covered with not less than No 28 MSG sheet
metal, (.015”), .015” thick stainless steel, .024”
aluminum or .020” copper.
Acceptable electrical
outlet area. Orient
electrical receptacle
so the length is
parallel to floor.
Use a flush mount
outlet for double
oven models.
C.
This appliance has been approved for 0” spacing to adjacent surfaces above the cooktop.
However, a 6” minimum spacing to surfaces less than 15” above the cooktop and adjacent
cabinet is recommended to reduce exposure to steam, grease splatter and heat.
To reduce the risk of burns or fire when reaching over hot surface elements, cabinet storage
space above the cooktop should be avoided. If cabinet storage space is to be provided above
the cooktop, the risk can be reduced by installing a range hood that projects at least 5” beyond
the front of the cabinets. Cabinets installed above the cooktop must be no deeper than 16”.
4” (3”
on double
ovens)
30”
Unit will not mount flush
to counter when heights
are less than 36”.
A
NOTE C
B
A
C
Both
Sides
29
7
8
”
36”
45
1
8
” (47
7
8
” on
single oven)
29
7
8
”
36
5
8
”
47”
(36” to
cooktop
height)
47
5
8
”
(45
1
8
” on
double oven)
29
7
8
”
(25
3
4
” on
double oven)
NOTE:
Rear wall
to front
of door
glass.
NOTE:
Rear wall
to front
of door
glass.
25
1
2
”
25
3
4
”