GE PVB94DTBB Quick Specs
GE PVB94DTBB Manual
 |
View all GE PVB94DTBB manuals
Add to My Manuals
Save this manual to your list of manuals |
GE PVB94DTBB manual content summary:
- GE PVB94DTBB | Quick Specs - Page 1
for installation of motor and blower assembly in an indoor remote location. For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at geappliances.com or call GE Answer Center® service, 800.626.2000. * Listed by Underwriters Laboratories Specification Revised - GE PVB94DTBB | Quick Specs - Page 2
GE Profile™ or GE® appliance questions, visit our website at geappliances.com or call GE Answer Center® service, 800.626.2000. Plan the Ductwork 1. T his downdraft floor joists, wall joists, wall studs, electrical wiring or plumbing for possible interference. Specification Revised 12/11 220982 - GE PVB94DTBB | Quick Specs - Page 3
LO 1 3 2 • Optional Indoor Remote Blower Kit - JXRB67 • Model PVB94DTBB - Black on Black PVB37NBB For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at geappliances.com or call GE Answer Center® service, 800.626.2000. Specification Revised 12/11 220982
-
1 -
2 -
3
 |
 |
For answers to your Monogram,
®
GE Profile
™
or
GE
®
appliance questions, visit our website at
geappliances.com or call GE Answer Center
®
service, 800.626.2000.
220982
Specification Revised 12/11
Listed by
Underwriters
Laboratories
PVB94DT
GE Profile
™
30" Telescopic Downdraft System
Venting Options (in inches)
Through the Floor
In Cabinet Discharge (Down)
In Cabinet Discharge (Right)
In Cabinet Discharge (Left)
Note:
Telescopic downdraft vents are not
recommended to be installed with cooktops that are
flush mounted.
Approved for use with the following GE Profile
™
and
GE cooktops–30" electric models, 30” gas sealed
burner models and 30" induction models.
Not Approved for use with standard burner gas
cooktops.
Note:
The cooktop must be at least 26" deep with a
flat surface area of 23-1/2" or more, front to back. In
addition, other clearances to the front edge of the
countertop must be considered.
Note:
Dimensions shown are for reference only. Before
cutting out countertop, refer to instructions packed with
downdraft and cooktop
.
Note: Installation on cabinets/countertops against
the wall will not be possible in most applications.
Against the wall installations are limited to
dimension requirements. Refer to installation
instructions packed with product for further details.
JXRB67 Indoor Remote Accessory.
Optional
accessory may be ordered for installation of motor
and blower assembly in an indoor remote location.
Dimensions and Installation Information (in inches)
*