Graco 8402L04 User Manual
Graco 8402L04 - SnugRide Infant Car Seat Base Manual
 |
UPC - 047406047468
View all Graco 8402L04 manuals
Add to My Manuals
Save this manual to your list of manuals |
Graco 8402L04 manual content summary:
- Graco 8402L04 | User Manual - Page 1
understand both the owner's manual from the infant restraint and these instructions before using the infant restraint and base. Keep this sheet with the instruction booklet in the pocket of your infant restraint for reference. This base can only be used with a Graco® Infant Restraint. If you do - Graco 8402L04 | User Manual - Page 2
. ‹ Belt MUST go under tongue Œ 3. Tighten the vehicle seat belt. Refer to your vehicle owners manual and the instructions in your infant restraint owner's manual on tightening your vehicle belt . 4. Push the infant restraint down into the base and make sure that you hear a "click". Pull up - Graco 8402L04 | User Manual - Page 3
may have See your vehicle owner's manual for exact different LATCH locations. locations, anchor identification, and requirements for use with an infant restraint. Vehicle Lower Anchor Points Vehicle Seat Crease Using LATCH to Install Base 1. For ease of installation, extend LATCH - Graco 8402L04 | User Manual - Page 4
Storing LATCH 1. For ease of storing, extend LATCH to its maximum length. 2. Locate the storage bars on bottom of infant restraint base ‹. 3. Fasten end of LATCH (without adjustment belt) onto storage bar. 4. Repeat Step 3 for LATCH with adjustment belt. After fastening onto storage bar, pull on - Graco 8402L04 | User Manual - Page 5
seguido detenidamente todos los pasos en el manual del propietario de su sistema de seguridad para niños. ecline the infant restraint/base on the vehicle seat. Use it AFTER you have carefully followed all of teps in your infant restraint owner's La base ajustable se usa junto con el nivel indicador - Graco 8402L04 | User Manual - Page 6
del propietario del vehículo y las instrucciones en el manual del sistema de seguridad para niños sobre cómo ajustar el cinturón del vehículo . 4. Empuje el sistema de seguridad hacia abajo en la base y asegúrese de que escucha un "clic". Tire hacia arriba del sistema de seguridad para ni - Graco 8402L04 | User Manual - Page 7
de vehículos disponen de otras ubicaciones del sistema LATCH. Vea el manual del propietario de su vehículo para informarse sobre las ubicaciones exactas, Asegúrese que el LATCH esté DEBAJO de la lengüeta de la base . El cinturón debe mantenerse plano sin torcerse. 4. Enganche los conectores - Graco 8402L04 | User Manual - Page 8
Almacenamiento del LATCH 1. Para facilitar el almacenamiento, extienda el LATCH hasta el máximo. 2. Ubique las barras de almacenamiento en el fondo de la base del sistema de seguridad ‹. 3. Ajuste el extremo del LATCH (sin el cinturón de ajuste) sobre la barra de almacenamiento. 4. Repita el Paso 3
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
© 2002 Graco
447-4-02
Adjustable Infant Restraint Base
See infant restraint owner’s manual for
complete installation instructions.
Base with LATCH
You must read and understand both the owner’s
manual from the infant restraint and these
instructions before using the infant restraint and
base. Keep this sheet with the instruction booklet
in the pocket of your infant restraint for reference.
This base can only be used with a Graco
®
Infant Restraint.
If you do not have instructions for your infant
restraint or if you have any questions about
your product, call Graco at 1-888-224-6549 or
visit our website at www.gracobaby.com.
ecline the infant restraint/base on the vehicle seat. Use it AFTER you have carefully followed all of
teps in
your infant restraint owner’s
The adjustable base is used along with the level indicator on the side of your infant restraint. To check the proper angle of
the infant restraint, first make sure the vehicle is on level ground and that the infant restraint/base is not tilted sideways on
the vehicle seat. Then check the level indicator. You must look straight on at the indicator.
If the indicator shows ONLY blue, the infant restraint is properly leveled.
If any orange is showing in the level indicator, the infant restraint is
either too upright or too reclined.
To lower the foot: pull down on the bottom of the foot to the desired
setting to adjust the recline
.
To raise the foot: set the base on a flat surface, push in on the fingers
on the base and push down on the base to adjust the recline
.
If there is still orange in the level indicator when the foot is completely
extended then place a rolled towel under the foot until
ONLY
blue shows.
Tighten belt through base, then reinstall infant restraint. Level indicator
should now show
ONLY
blue—if you still see orange, re-adjust recline
.
Your new infant restraint base is equipped with Graco’s recline adjustment foot, which helps to properly recline the infant
restraint/base on the vehicle seat. Use it AFTER you have carefully followed all of the steps in your infant restraint owner’s
manual.
1