Haier BW-Z20A User Manual
Haier BW-Z20A Manual
 |
View all Haier BW-Z20A manuals
Add to My Manuals
Save this manual to your list of manuals |
Haier BW-Z20A manual content summary:
- Haier BW-Z20A | User Manual - Page 1
XQBM20-E Fully-auto Washing Machine Contents Before using Please read this manual carefully before using. Retain it for reference Please check if 12 The washing is finished 12 Disposal after washing 13 Trouble shooting Answer to question......14 Packing list 15 Specification the back cover - Haier BW-Z20A | User Manual - Page 2
Names of the parts ÊBe¹foreÓUsÃingÖ ® Top lid Control panel seat lint filter Inner tub Pulsator Cabinet Cabinet,lower Power line Water level knob Control panel film Control panel film Water inlet valve Water absorption gasket Handle Drain Hose Adjustable foot Back cover Fixed Foot(3 Pcs) - Haier BW-Z20A | User Manual - Page 3
bad, to avoid risk it is required to have it replaced by the technicians of our special shop or our agent or the after-sale service department. Keep the pin of the power plug clean. Do not put the machine at damp place like the bathroom. Never wash it with water - Haier BW-Z20A | User Manual - Page 4
lint filter in good condition, and install it to proper position. If the lint filter is lost or damaged, please contact the local after-sales service department of our company. Before washing,please check if the water tap is open,and if the water inlet pipe is connected properly. It is - Haier BW-Z20A | User Manual - Page 5
Installation and adjustment Before Using Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. After you open the package, please lean the washing machine gently down on - Haier BW-Z20A | User Manual - Page 6
Before Using How to change the direction of the drain hose 1.Lean the machine down gently with the front surface facing the ground. Loosen the eight screws by a cross screwdriver. 3.Extend the drain hose from the left side. Push the drain hose into the groove with hands. Back Bottom plate Front - Haier BW-Z20A | User Manual - Page 7
Install the water inlet hose Before Using Confirm the water faucet 1. Insert a new flat washer into the end of the inlet hoses. Firmly put the washers in the coupling. Note: You may have to use pliers. to tighte.n the coupling. Do not over tighten because you may cause damage to the valve. 2. - Haier BW-Z20A | User Manual - Page 8
1 Preparation before washing Using process Preparation before washing 1.Connect the water inlet hose and open the water tap . 2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. - Haier BW-Z20A | User Manual - Page 9
2 Put in the laundries Using process The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition that can be washed or spinned in one time. One time washing quantity shall be lower than the rated capacity. The largest capacity of this - Haier BW-Z20A | User Manual - Page 10
. The usage and use level of the whitener please refer to the User's manual of it. For the whitener in powder, first dissolve it then use. How ,water quantity and water level. The above method is only applicable in manual selection of the water level. Selection of the water level,water quantity and - Haier BW-Z20A | User Manual - Page 11
Close the top lid Using process * If the top lid is not closed , the machine will stop working in the midway. Water level selection Water level selection Middle High Reset Low * According to the capacity of the laundries, choose the three water levels "High" "Middle" " Low" . * After the - Haier BW-Z20A | User Manual - Page 12
Using process Procedure selector knob (procedure running time: Time Process Soak Wash Procedure Rinse Spin The dirtiest(1~6) 19 15 Soak-wash 2 times 5 Dirtier(1~6) 15 Soak-wash 2 times 5 Ordinary(3~6) 5 Soak-wash 1 times 5 Rinse(4~6) Spin(5~6) Soak-wash 1 times 5 5 Wash(6~7) 6 - Haier BW-Z20A | User Manual - Page 13
Using process Choose the wash procedure according to the above instruction. Push in the procedure controller knob and turn it clockwise to the expected procedure and then pull out the knob, the machine begins to work. - Haier BW-Z20A | User Manual - Page 14
Disposal after washing Using process Cleaning the lint filter The lint filter must be used during washing. It must be cleaned in time after each using. 1. Take off the lint filter Put hand at the indicated position. Push down to take it off. ( See to Figure 1) 2. Clean the lint Put it in water and - Haier BW-Z20A | User Manual - Page 15
sometimes. Please check again before you send it to repair. If there are real troubles, please call to service department or local dealer . Do not repair it by yourself. Problems Possible causes Solution The machine stops in spinning The top lid is not closed. Close the top lid. The draining - Haier BW-Z20A | User Manual - Page 16
Packing list User's manual One Components of the water inlet hose One Fully-auto washing machine One Lint filter One 14 - Haier BW-Z20A | User Manual - Page 17
Specification Model XQBM20-E Rated voltage. frequency 220-240V .50Hz Rated washing / spinning capacity 2.0kg Water level / Water quantity (about) High / 20L, Middle / 15L, Low / 7L Max water consumption About 60L (High water level; Normal procedure) Injection pressure 0.03MPa-0.78MPa Rated
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
 |
 |
Names of the parts
.............
the 2
nd
cover
Safety precautions
.............................
1
Installation and adjustment
.................
3
Install the water inlet hose
..................
5
Preparation
before washing
.............
7
Put in the laundries
............................
8
Add the detergent
..............................
9
Close the top lid
...............................
10
Select water level
.............................
10
Select program
.................................
10
Turn the knob.
.................................
12
The washing is finished
...................
12
Disposal after washing
.....................
13
Trouble shooting Answer to question
......
14
Packing list
.......................................
15
Specification
.................
the back cover
Contents
Before using
Using
process
User's Manual
Fully-auto
Washing
Machine
XQBM20-E
Please read this manual carefully before using.
Retain it for reference
Please check if the power receptable is earthed
reliably before usage to guarantee your safety.
The manufacturer is not responsible for any
risks occurred owing to disobey these
stipulations.