Haier HR-SC User Manual
Haier HR-SC Manual
 |
View all Haier HR-SC manuals
Add to My Manuals
Save this manual to your list of manuals |
Haier HR-SC manual content summary:
- Haier HR-SC | User Manual - Page 1
SOL H PRE INT WT HC T-DISP MPa ON/OFF SET REG MODE Read the operation instruction carefully before use. Ensure good storage of the operation instruction for late consultation. Safety information (read it before use)...... 2 Installation introduction 3 Installation cautions 3 Installation of - Haier HR-SC | User Manual - Page 2
the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • This experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for - Haier HR-SC | User Manual - Page 3
Installation introduction Installation cautions The solar station doesn't provide water pressure protective devices, heating Notice element and heating element overheating protective devices (thermal cut-out). Those shall be inside the water storage tank. Their safty and installation shall be - Haier HR-SC | User Manual - Page 4
station are G1/2" female standard thread). Notice Installation position on the wall of installation hanger of solar station must be fixed properly and wall supporting load must be two times of weights of solar station. The hanger holes on the back of solar station Hanger of solar station Small - Haier HR-SC | User Manual - Page 5
Installation introduction „„ Schematic diagram of solar hot water supply system Blind tube for measuring temperature Liquid inlet of solar collector Circulation inlet tube Liquid outlet of solar collector Solar collector temperature sensor wire Circulation output tube Check valve Plate solar - Haier HR-SC | User Manual - Page 6
Installation introduction Circuit connection Screw off bolts on the bottom shell of solar station, open its front shell and connect the circuit as shown in the diagram. „„ Circuit connection of water storage tank Notice • The nominal cross-sectional area of the wires shall not less than 1.5mm2. - Haier HR-SC | User Manual - Page 7
Installation introduction „„ Connection of solar collector temperature sensor 1 Find solar collector temperature sensor on the corresponding interface on the power plate. 2 Cut it at the position where is 150mm away from the terminal and strip the wire. (connect another lead according to the actual - Haier HR-SC | User Manual - Page 8
Installation introduction Priming antifreeze 1 Screw off the priming vent cap of priming valve, close the bigger check valve in the middle of priming valve ( when two blades on the valve handle is vertical to axle of valve, it is closed) and open another two smaller check valves. 2 Connect the - Haier HR-SC | User Manual - Page 9
Directions for use After the installation of all the tubes and wiring, ensure that water storage tank is full of water and that solar collector circulation system is full of circulation media without leakage, then connect the power of solar station. After connecting the power, solar station will - Haier HR-SC | User Manual - Page 10
Directions for use „„ Solar energy indication light (green) While it is lighted up, it is indicated that water heater is in solar energy heating working mode. „„ Instant heating indication light (green/red) While the green light is on, it is indicated that water heater is in instant heating working - Haier HR-SC | User Manual - Page 11
Directions for use Operation methods Under various working mode, the operations are as follows: „„ The solar heating mode is as follows: 1 Press the button 2 Press the button , then A twinkles, press the button , then B twinkles, press the button to set the current time, "hour" . to set the - Haier HR-SC | User Manual - Page 12
Directions for use ■■ Directions After setting the dated time and temperature, the system will heat water to the dated temperature before dated time. When it is the dated time, the system will maintain the temperature for 30 minutes; while the current temperature is 5°C lower than the set - Haier HR-SC | User Manual - Page 13
Directions for use „„ The intelligent heating mode is as follows: Press the button again, then B twinkles; press the button to set the temperature for intelligent heating. The setting range is from 30°C to 75°C with the default value 65°C. ■■ Directions In the intelligent heating mode, the system - Haier HR-SC | User Manual - Page 14
board SW PB: power board SW: 10-core signal wire RY1 and RY2: relays CD CD: coil for electricity leakage detection L MT: manual reset temperature controller E EH: electrical heater N CP: circulation pump TS1: temperature sensor for the PB water tank TS2: temperature sensor for the - Haier HR-SC | User Manual - Page 15
is damaged. Circuit failure and creepage in the system. Water storage tank is not full of water, electrical heater is burned without water or manual operation which makes the sensor probe increase too much in the short time. Check temperature sensor of solar collector for damage. Check temperature - Haier HR-SC | User Manual - Page 16
$4)+JOEE V98497 0040502470 V98497 0040502470 1.
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
 |
 |
HR-SC
OPERATION INSTRUCTIONS
Haier solar station
OPERATION INSTRUCTIONS
Haier solar station
HC
SOL
H
WT
PRE
INT
T-DISP
SET
REG
MODE
Read the operation instruction
carefully before use.
Ensure good storage of the operation
instruction for late consultation.
ON/OFF
MPa
Safety information
(read it before use)
.....
2
Installation introduction
..............
3
Installation cautions
.......................
3
Installation of the solar station ..4
Circuit connection
...........................
6
Installation of expansion tank
and priming valve
..........................
7
Priming antifreeze
...........................
8
Directions for use
.........................
9
Directions for buttons and
indication lamps
..............................
9
Operation methods
........................
11
Electric principle diagram, technical
data and packing sheet
................
14
Electric principle diagram
............
14
Technical data
...................................
14
Packing sheet
....................................
14
Questions and answers
................
15
CSH09J0455.indd
1
11/6/2009
4:08:16 PM