Haier XQB70-10 User Manual
Haier XQB70-10 Manual
 |
View all Haier XQB70-10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Haier XQB70-10 manual content summary:
- Haier XQB70-10 | User Manual - Page 1
User's manual XQB70-10 Full Automatic Washing Machine Please read this manual carefully before use. Please retain it attentively for washing 7 Put in the laundries 8 Put in the detergent 9 Use the operation buttons 10 Close the top lid 14 Finish washing 14 Disposal after washing 15 Trouble - Haier XQB70-10 | User Manual - Page 2
frontier science.To facilitate using it, please read this manual carefully and operate this machine according to it. Top lid B Detergent box foot (3) Accessories bottom plate (one) the end connecting to the washing machine jointer connecting the water inlet hose water inlet hose and the water - Haier XQB70-10 | User Manual - Page 3
out with hand three-phase wire,please use three-phase rec- while the washing machine runs normally. eptacle.The earthing terminal of the receptacle Be sure to pull by the technicians of our special shop or the after-sale service department. Keep the pin of the power plug clean,if the power plug - Haier XQB70-10 | User Manual - Page 4
the machine. Keep the machine away from direct sunlight and heat source like the heater. To. prevent your laundries and washing machine from is lost or damaged, please contact the local after-sales service department of our company. Before washing,please check if the water tap is open ,and if - Haier XQB70-10 | User Manual - Page 5
and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Install the bottom plate After you open the package, please lean the washing machine gently down on soft items ( like the - Haier XQB70-10 | User Manual - Page 6
direction changing 4.Install the bottom plate (as per indicated before), then lift the machine up gently. Page 3 Usage of the drain hose The drain hose shall or the drainage will not be smooth, and cost such long time that the machine may stop at mid way. 2.Do not trample or press the drain hose. - Haier XQB70-10 | User Manual - Page 7
Install the water inlet hose Confirm the water tap Before Using Water tap,suitable Water tap,not suitable Outlet end surface >10mm It is required that the front end shall be longer than 10mm. The outlet end surface of the tap shall be flat and smooth. If not please file it to avoid leakage. - Haier XQB70-10 | User Manual - Page 8
Using Connection between the water inlet hose and the washing machine 1.Do not take off the water absorption Nut of the locking lever. Push down the slider. Then pull off the water inlet hose. If the machine is used more than once every week, the jointer of the water inlet hose can be kept on - Haier XQB70-10 | User Manual - Page 9
long fiber,please first turn the inside out before putting them into the water. f.Do not put the laundries polluted with chemicals directly into the washing machine. g.For those small laundries ,laundries likely to be twisted or worn,and woolen laundries, please put them into mesh bag before wasing. - Haier XQB70-10 | User Manual - Page 10
refer to the largest weight of the standard laundries under dry condition that can be washed or spinned in one time. One time washing quantity shall be lower than the rated capacity. The largest capacity of this machine is 7.0kg. The thickness, size, type of the cloth will influence the actual - Haier XQB70-10 | User Manual - Page 11
. The whitener shall not touch the laundries directly. Refer to the user's manual for the usage and quantity of the whitener. For powder whitener, please dissolve it before use. How to use the washing powder Direct dissolved in the machine 1.Fill water to "Low" water level. 2.Add the power. Run for - Haier XQB70-10 | User Manual - Page 12
or indicate the selected mode Flashing rapidly: indicate abnormal condition " Process select"button . 9 10 7 8 5 6 3 4 1 2 Water level Selection STANDARD JEANS GENTLE QUICK WASH SOAK WASH RINSE SPIN Program Selection Procedure Selection Water level button The user selects a suitable - Haier XQB70-10 | User Manual - Page 13
the button, the nixie tube displays the reserved hrs to the wash cycle end. The indicator flashes to indicate in-reservation. Remarks: After pressing "Power On/Off" to connect power supply, if the washing machine lasts idle more than 10 min, it would automatically shut off the supply. RESERVE HOURS - Haier XQB70-10 | User Manual - Page 14
indicator on. Refer to the "Button of 'program'"paragraph on page 10. Example: Use the "Quick" program for slightly soiled articles. Page 11 When "standard" or "Jeans" program is selected, the washing machine will perform full-automatically controlled fuzzy program to set water level, water - Haier XQB70-10 | User Manual - Page 15
spinning after manual washing Soak Wash Rinse Spin When the laundries need only Soak Wash Rinse Spin 4 Spin(spin after drain) spinning after manual washing (first drain then spin) 5 Soak,wash,rinse,spin standard dosages and water levels" and "Button of Water level" on page 10. Page 9 Page - Haier XQB70-10 | User Manual - Page 16
the supply and reselect. the washing will finish about 18 hours later 6 Press the "start/pause" button 5 Close the top lid Except water filling and draining, if the top cover is opened, the washing machine will stop running and alarm. 6 Finish washing The washing machine cuts off the power supply - Haier XQB70-10 | User Manual - Page 17
the supply and reselect. the washing will finish about 18 hours later 6 Press the "start/pause" button 5 Close the top lid Except water filling and draining, if the top cover is opened, the washing machine will stop running and alarm. 6 Finish washing The washing machine cuts off the power supply - Haier XQB70-10 | User Manual - Page 18
Trouble , please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. buzzing Poor or no waterfall flow The machine does not act Not wash Not spin There's abnormal sound inside the machine The water faucet leaks The reason The - Haier XQB70-10 | User Manual - Page 19
water filling. Supplementary water filling 48 s after sensor tests cloth material. Packing list Name User's manual Components of the water inlet hose Bottom plate Tapping screws ST4x16 Automatic washing machine Quantity One One One Eight One Storage position Inside the document bag Inside the - Haier XQB70-10 | User Manual - Page 20
Specification Model XQB70-10 Rated voltage frequency 220V~ 50Hz Rated washing / spinning capacity 7.0kg (weight of standard dry cloth) Water level/Water quantity (about) Max water consumption pressure About 126L (High water level; Standard program) 0.03MPa-0.78MPa Rated washing power Rated
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
 |
 |
Names
of
the
parts
.............
the
2
nd
cover
Safety
precautions
.......................
1
Introduction
of
the
special
functions
.........
3
Installation
and
adjustment
..................
3
Install
the
water
inlet
hose
............
5
Preparation
before
washing
.............
7
Put
in
the
laundries
.........................
8
Put
in
the
detergent
.......................
9
Use
the
operation
buttons
................
10
Close
the
top
lid
........................
14
Finish
washing
............................
14
Disposal
after
washing
....................
15
Trouble shooting
Answer to question
.....
16
Packing
list
...................................
17
Specification
.........................
the
back
cover
Contents
Before using
Using
process
Please read this manual carefully before use.
Please retain it attentively for future reference.
User's
manual
Full
Automatic Washing
Machine
XQB70-10
Please check if the power receptacle is earthed
reliably before usage to guarantee your safety.
The manufacturer is not responsible for any
risks
occurred owing to disobey these
stipulations.