HP 24-e000 Optical Drive Replacement Instructions
HP 24-e000 Manual
 |
View all HP 24-e000 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP 24-e000 manual content summary:
- HP 24-e000 | Optical Drive Replacement Instructions - Page 1
Optical Drive Replacement Instructions 854125-001 Before you begin Observe the following requirements before removing and replacing the optical drive. WARNING: Never open the cover with the power cord - HP 24-e000 | Optical Drive Replacement Instructions - Page 2
3. Locate the optical drive: 1. Memory modules 2. Optical drive 3. Hard drive 4. Disconnect the data and power cables from the rear of the drive (1), push the green release latch toward the center of the drive (2), and then slide the drive forward and out of the bay through the front bezel (3). 5. - HP 24-e000 | Optical Drive Replacement Instructions - Page 3
button to turn on the computer. back of the computer. © Copyright 2016 HP Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and
-
1 -
2 -
3
 |
 |
854125-001
1
Optical Drive Replacement Instructions
Before you begin
Observe the following requirements before removing and
replacing the optical drive.
WARNING
: Never open the cover with the power cord
attached or power applied. You might damage your
computer or be injured by the spinning fan blades.
WARNING
: Avoid touching sharp edges inside the
computer.
WARNING
: Keep your hands away from the moving fan.
WARNING
: Keep fingers and tools clear of the fan when
the power is applied.
CAUTION
: Static electricity can damage the electronic
components inside the computer. Discharge static
electricity by touching the metal cage of the computer
before touching any internal parts or electronic
components.
Tools needed
Phillips #2 screwdriver
Small screws are easily lost. Remove screws over a
surface that enables you to retrieve them if they fall.
NOTE
: Computer appearance and features may vary by
model.
Removing the optical drive
1.
Disconnect the power cord and all attached cables from
the back of the computer.
2.
Remove the access panel by loosening the captive
screw
(1)
, sliding the access panel back, and then
lifting it off the computer
(2)
.
854125-001