HP 24-e000 Hard Drive/Solid-State Drive Replacement Instructions
HP 24-e000 Manual
View all HP 24-e000 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP 24-e000 manual content summary:
- HP 24-e000 | Hard Drive/Solid-State Drive Replacement Instructions - Page 1
Hard Drive/Solid-State Drive Replacement Instructions 925496-001 Before you begin Observe the following requirements before removing and replacing the hard drive or solid-state drive. WARNING: To reduce the risk - HP 24-e000 | Hard Drive/Solid-State Drive Replacement Instructions - Page 2
3. Locate the hard drives: 1. Top hard drives 2. Optical drive 3. Side hard drives NOTE: Illustration shows drive location, but drives cannot be seen from the outside of the computer. 4. To remove from the top of the computer: Open the hard drive doors (1). Slide the locking latch down to unlock - HP 24-e000 | Hard Drive/Solid-State Drive Replacement Instructions - Page 3
9. 3.5-inch hard drive: At the front of the drive, pull the sides of the drive tray outward (1), and then remove the drive from the tray (2). 10. 2.5-inch solid state drive: Remove the four mounting screws that secure the drive to the drive tray (1), and then remove the drive from the tray (2). 11 - HP 24-e000 | Hard Drive/Solid-State Drive Replacement Instructions - Page 4
3. Slide the drive assembly into the drive bay until it snaps into place (1), and then connect the power (2) and data (3) cables to the drive. 4. Position the access panel back into place on the side of the computer (1), and then slide the release latch to the locked position (2). 5. To install - HP 24-e000 | Hard Drive/Solid-State Drive Replacement Instructions - Page 5
recovery discs. To install the operating system, refer to the instructions included with your system recovery discs, or for U.S. product support, go to http://www.hp.com/go/contactHP. For worldwide product support, go to http://welcome.hp.com/country/us/en/wwcontact_us.html. IMPORTANT: Do not turn
925496-001
1
Hard Drive/Solid-State Drive Replacement
Instructions
Before you begin
Observe the following requirements before removing and
replacing the hard drive or solid-state drive.
WARNING
: To reduce the risk of serious injury or
damage to the equipment, do not open the chassis cover of
any unit with a 750W power supply. To determine if you
have a 300W, 500W or 750W power supply, refer to the
label on the rear of the computer.
CAUTION
: Never open the cover while the power cord is
attached. You might damage your computer or be injured
by the spinning fan blades.
CAUTION
: Avoid touching sharp edges inside the
computer.
NOTICE
: A hard drive is extremely sensitive to shock and
impact. Do not bang or drop it. Do not touch the circuit
board.
NOTICE
: Static electricity can damage the electronic
components inside the computer. Discharge static
electricity by touching the metal cage of the computer
before touching any internal parts or electronic
components.
Tools needed
Phillips #2 screwdriver
Small screws are easily lost. Remove screws over a
surface that enables you to retrieve them if they fall.
Removing a hard drive or solid-state drive
1.
Press the power button to turn off the computer.
2.
Disconnect the power cord and all attached cables
from the computer.
925496-001