HP 24-e000 Hard Drive Replacement Instructions 1
HP 24-e000 Manual
 |
View all HP 24-e000 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP 24-e000 manual content summary:
- HP 24-e000 | Hard Drive Replacement Instructions 1 - Page 1
Hard Drive Replacement Instructions 854126-001 Before you begin Observe the following requirements before removing and replacing the hard drive. WARNING: Never open the cover with the power cord - HP 24-e000 | Hard Drive Replacement Instructions 1 - Page 2
3. Locate the hard drive: 1. Memory modules 2. Optical drive 3. Hard drive 4. Remove the front bezel by lifting the three tabs that secure the top of the bezel to the front of the computer (1), and then rotating the bezel downward and off the computer (2). 5. Remove the three Phillips screws that - HP 24-e000 | Hard Drive Replacement Instructions 1 - Page 3
Replacing the hard drive 1. Insert the hard drive into the drive cage and align the screw holes in the drive with the holes in the cage (1). Replace the four Phillips screws (2). 2. Insert the drive cage into the computer (1), and then connect the power and data cables to the back of the hard drive - HP 24-e000 | Hard Drive Replacement Instructions 1 - Page 4
the instructions included with your system recovery discs, or for U.S. product support, go to http://www.hp.com/go/contactHP. For worldwide product support, go for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should
-
1 -
2 -
3 -
4
 |
 |
854126-001
1
Hard Drive Replacement Instructions
Before you begin
Observe the following requirements before removing and
replacing the hard drive.
WARNING
: Never open the cover with the power cord
attached or power applied. You might damage your
computer or be injured by the spinning fan blades.
WARNING
: Avoid touching sharp edges inside the
computer.
WARNING
: Keep fingers and tools clear of the moving
fan when the power is applied.
CAUTION
: Static electricity can damage the electronic
components inside the computer. Discharge static electricity
by touching the metal cage of the computer before touching
any internal parts or electronic components.
CAUTION
: A hard drive is extremely sensitive to shock
and impact. Do not bang or drop it.
Tools needed
Phillips #2 screwdriver
Small screws are easily lost. Remove screws over a
surface that enables you to retrieve them if they fall.
NOTE
: Computer appearance and features may vary by
model.
Removing the hard drive
1.
Disconnect the power cord and all attached cables from
the back of the computer.
2.
Remove the access panel by loosening the captive
screw
(1)
, sliding the access panel back, and then
lifting it off the computer
(2)
.
854126-001