HP Color LaserJet Managed MFP E78323-E78330 Engine Install Guide

HP Color LaserJet Managed MFP E78323-E78330 Manual

HP Color LaserJet Managed MFP E78323-E78330 manual content summary:

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7

89.55 kg
176.92
lb
1
1.1
1.2
1
WARNING:
Make sure the work area is free of debris
and the floor is not slippery or wet.
CAUTION:
The printer assembly is heavy. Four people
must lift and install it on the dual cassette feeder
(DCF) (Y1F97A), the 2000-sheet high capacity input
(HCI) (Y1F99A), or the stand (Y1G17A).
Unpack and acclimate the printer.
CAUTION:
Before the printer is powered on, make sure that the room and equipment are at least 15°C (59°F).
NOTE:
Leave the printer on the shipping pallet until it is ready to install on a DCF, HCI, or stand.
Remove the printer, imaging drums, toner collection unit (TCU), and associated hardware from
the box. After unpacking the printer and supplies, allow them to acclimate for four hours.
NOTE:
If the printer and hardware were stored below 0°C (32°F), it may take them longer
to acclimate.
CAUTION:
Do not remove the shipping tape or protective packing materials until after the
printer is installed on a DCF, HCI, or stand. (Step 3.2)
NOTE:
Imaging drums are stored in the output bin area below the automatic document feeder.
Pull the protective clear plastic down to the base of the printer to
allow access to lifting points.
support.hp.com
Engine Install Guide
HP recommends reviewing
the video before performing
the installation.
HP Color LaserJet Managed MFP E78323, E78325, E78330
HP Color LaserJet Managed MFP E77822, E77825, E77830