HP D5970A HP Netserver LC Windows NT 3.51 Installation Guide
HP D5970A - NetServer - LCII Manual
 |
View all HP D5970A manuals
Add to My Manuals
Save this manual to your list of manuals |
HP D5970A manual content summary:
- HP D5970A | HP Netserver LC Windows NT 3.51 Installation Guide - Page 1
HP NetServer LC Microsoft Windows NT 3.51 Installation Guide This document presents the most important information that you need to install Windows NT version 3.51. Please check with HP Support for information regarding newer versions of Windows NT after they are released by Microsoft.. The first - HP D5970A | HP Netserver LC Windows NT 3.51 Installation Guide - Page 2
51 provides a built-in Disk Array driver. However, if your HP NetServer system has drives connected to an HP Disk Array Controller accessory board, you should use the HP Disk Array driver from the Drivers Diskette. You can create the Drivers Diskette from the HP NetServer Navigator CD-ROM. DAT Drive - HP D5970A | HP Netserver LC Windows NT 3.51 Installation Guide - Page 3
Refer to the DAT drive manual for instructions on removing the terminator. Boot Guide Before installing the Operating System, please read this section carefully. Configuring Logical Disk Size for the Disk Array Controller During system configuration, the Jet Set Utility on the HP NetServer Navigator - HP D5970A | HP Netserver LC Windows NT 3.51 Installation Guide - Page 4
Boot the HP NetServer using the HP NetServer Navigator CD-ROM. Run Configuration Assistant and follow the instructions to create a driver diskette. AIC 77xx NT". Select this driver and press Enter to install. This driver supports the embedded SCSI Controller and the HP EISA Fast SCSI-2 Controller ( - HP D5970A | HP Netserver LC Windows NT 3.51 Installation Guide - Page 5
create the HP DeskDirect Adapter Support Diskette if you want to perform troubleshooting or to reconfigure the Adapter for Full Duplex or I/O-mapped mode of data transfer. You can create the HP Support Diskette in the Disk Library option of the Navigator CD-ROM. The NDIS 3.0 driver and its OEMSETUP - HP D5970A | HP Netserver LC Windows NT 3.51 Installation Guide - Page 6
network adapter driver. Use the Drivers Diskette and follow the instructions given below to configure your HP DeskDirect Network driver from the Support Disk. If this occurs, copy the driver file "HPDDND3.SYS" from the A:\NICDRV directory of the Drivers Diskette into the \SYSTEM32\DRIVERS - HP D5970A | HP Netserver LC Windows NT 3.51 Installation Guide - Page 7
CD \WINNT35\SYSTEM32\DRIVERS REN HPDDND3.SYS HPDDND3.OLD COPY A:\NICDRV\HPDDND3.SYS HPDDND3.SYS 7. You have completed all the steps required for the installation of network drivers to create the Drivers Diskette. Steps for Adding the HP NetRAID Adapter Drivers Follow these instructions only if - HP D5970A | HP Netserver LC Windows NT 3.51 Installation Guide - Page 8
the program. Shutdown Windows NT and reboot. Section 3. Troubleshooting The following is a list of known problems and workarounds with Microsoft Windows NT. 1. If the boot NT installation program. 2. If the Network Adapter driver fails to start or does not appear to be working correctly, examine the Event - HP D5970A | HP Netserver LC Windows NT 3.51 Installation Guide - Page 9
the problem in more detail. F. If no readable string is present, this typically indicates that the driver failed the HP-supplied SCSI driver is installed. This driver is required for supporting the SCSI CD-ROM. HP Networking BBS: 208-344-1691 (14,400 baud) HP NetServer BBS: 408-553-3500 (14,400 baud - HP D5970A | HP Netserver LC Windows NT 3.51 Installation Guide - Page 10
Section 5. HP NetServer CD Status Report FAX HP has a new FAX service to ensure that you have access to the newest versions of HP NetServer system software. To obtain an HP NetServer CD Status Report via FAX, perform the following: 1. Call the HP FIRST FAX system at 1-800-333-1917, or if you are
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
 |
 |
HP NetServer LC
Microsoft Windows NT 3.51 Installation Guide
This document presents the most important information that you need to install
Windows NT version 3.51.
Please check with HP Support for information regarding
newer versions of Windows NT after they are released by Microsoft..
The first section
of this document is a list of helpful tips on Windows NT installation.
The second
section is a step-by-step installation guide.
Please see the CD-ROM-based
HP
Information Assistant
for additional detailed information to help you install Windows
NT.
NOTE
:
Hewlett-Packard has more than one Disk Array Controller
(DAC) for the NetServer product family.
In this document
the term "HP Disk Array" refers to the EISA and PCI Disk
Array Controller models C3609A and C3610A,
respectively.
The term "HP NetRAID" refers to the HP
NetRAID PCI Adapter model D4943A.
Table of Contents
Section 1.
Installation Tips
Extended Translation
Troubleshooting Host Adapter Configuration
Windows NT 3.51 Disk Array Driver
DAT Drive
Boot Partition
Windows NT Setup Utility
BusTech SCSI Controller
Windows NT Installation Tips
Section 2.
Windows NT
3.51 Installation Guide
Configuring Logical Disk Size for the Disk Array Controller
Booting from the Embedded SCSI Controller
Installing Windows NT 3.51
Installing HP DeskDirect Network Adapter Controller
Adding the HP NetRAID Adapter to an existing Windows NT system
Section 3.
Troubleshooting
Section 4.
On-Line Information and Software Sources