HP D5970A HP Netserver LH Pro NetRAID Config Guide for Windows NT4.0 Clusters
HP D5970A - NetServer - LCII Manual
View all HP D5970A manuals
Add to My Manuals
Save this manual to your list of manuals |
HP D5970A manual content summary:
- HP D5970A | HP Netserver LH Pro NetRAID Config Guide for Windows NT4.0 Clusters - Page 1
) LAN Power source System software: Navigator version Operating System Service pack HP NetServer LH Pro 6/200 Model 1 Each node must be the same model SPU, but may have different size main memory and cache. 2 HP Storage System/6 with HP NetRAID controller and HP disks. See Shared Storage below - HP D5970A | HP Netserver LH Pro NetRAID Config Guide for Windows NT4.0 Clusters - Page 2
slots: HP NetServer LH Pro 6/200 Model 1 200 MHz 2 (at least two are required) 4.05.14 PF or later Any size 128 MB minimum. Must be HP. 2 May Driver NetRAID Assistant SPU I/O slot SCSI ID Channels RAID level Logical disks Configuration options: HP NetRAID D4943A Use with HP Storage System/6 and HP - HP D5970A | HP Netserver LH Pro NetRAID Config Guide for Windows NT4.0 Clusters - Page 3
SPU hot swap cages Disk drives: Cables RAID arrays LANs LAN connection NIC: Model Driver SPU I\O slot HP Storage System/6 D3604B 1, 2 A cluster with a single storage cabinet has only one SCSI bus connected to HP NetRAID channel 0. A cluster with 2 storage cabinets must have one cabinet connected to - HP D5970A | HP Netserver LH Pro NetRAID Config Guide for Windows NT4.0 Clusters - Page 4
This page intentionally left blank. 4
1
HP NetServer LH Pro
with
NetRAID (HP Storage System/6)
Cluster Configuration Guide
18 November 1998
Introduction
This document defines the supported HP NetServer LH Pro configurations for Microsoft Cluster Server.
These configurations minimize single points of failure, provide maximum availability, and have been
certified by Hewlett-Packard and Microsoft.
This guide is prescriptive; it describes the HP NetServer LH
Pro configurations supported by HP.
Any configuration not expressly allowed by this guide will not be
supported by HP.
What’s Defined
•
Cluster
•
SPUs
•
Local and Shared Storage
•
Intra-cluster and Client LANs
Cluster
Type of SPUs
HP NetServer LH Pro 6/200 Model 1
Each node must be the same model SPU, but may have different size main
memory and cache.
Number of nodes
2
Shared Storage
HP Storage System/6 with HP NetRAID controller and HP disks.
See
Shared Storage
below.
LANs:
Client LAN
Any NIC that is HP and Microsoft approved.
See
Client LAN
below.
Intra-cluster
(Heartbeat) LAN
HP D5013A or
J3171A only with crossover cable. See
Intra-cluster LAN
below.
Power source
Direct from power mains, power conditioner or uninterruptable power
supply (UPS) using any power conditioner or UPS.
System software:
Navigator version
G.00.80 or later
Operating System
Microsoft Windows NT Server 4.0, Enterprise Edition.
Service pack
SP3 and hotfix "clusfixi", or later.
The hotfix is not required but is
recommended for clusters using 9.1GB and higher capacity drives.