HP D5970A hp netserver lp 2000r netraid-2m config guide — for Mic
HP D5970A - NetServer - LCII Manual
View all HP D5970A manuals
Add to My Manuals
Save this manual to your list of manuals |
HP D5970A manual content summary:
- HP D5970A | hp netserver lp 2000r netraid-2m config guide — for Mic - Page 1
Advanced Server Cluster Configuration Guide Introduction This document defines the server cluster configurations supported by Hewlett-Packard for interconnection of two HP Netserver LP 2000r servers and one or two HP Rack Storage/12 disk drive enclosure(s), with Microsoftâ Cluster Server software - HP D5970A | hp netserver lp 2000r netraid-2m config guide — for Mic - Page 2
SCSI bus SCSI IDs System software Navigator CD-ROM Operating system Service pack Power distribution Layout Specification One standard, two required for redundancy Note that in configurations with more than one NetRAID controller, fully populated PCI or hard drive slots, the second power supply - HP D5970A | hp netserver lp 2000r netraid-2m config guide — for Mic - Page 3
Server Specification I/O card slot PCI slot 1, NetRAID-2M shared storage controller Network interfaces Embedded NICs for both intra-cluster (heartbeat) and client LANs Boot device Embedded SCSI Intra-Cluster (Heartbeat) LAN Configuration Parameter Network Specification Connection NIC HP - HP D5970A | hp netserver lp 2000r netraid-2m config guide — for Mic - Page 4
Specification Connection NIC Any LAN Quantity Model One, minimum Embedded NIC - LAN B or any model that is on both the HP Tested Products List and the Microsoftâ Hardware Compatibility List. Driver If the NIC used is the same type as that of the intra-cluster LAN, then the client LAN driver - HP D5970A | hp netserver lp 2000r netraid-2m config guide — for Mic - Page 5
Configuration table in the guide for a list of cables that can be used. 3. One NetRAID-2M card may be used, and from one to two RS/12s are supported. A maximum of eight logical drives are supported for the cluster. lp2000r2k2m LAN A -heartbeat LAN B -client HP Netserver LP 2000r Cluster using - HP D5970A | hp netserver lp 2000r netraid-2m config guide — for Mic - Page 6
lp2000r2k2m Power Cabling to Separate Power Circuits 10/21/02 6 - HP D5970A | hp netserver lp 2000r netraid-2m config guide — for Mic - Page 7
2002 7 November 2001 13 August 2001 lp2000r2k2m Updated cabling diagram. Updated supported configurations and cabling information. Added qualifications for support of two NetRAID-2Ms, and updated diagrams. Added support for 1.26 GHz models. Initial release. ãCopyright 2001, Hewlett-Packard Company
HP Netserver LP 2000r with
NetRAID-2M (HP Rack Storage/12)
Windows
±
2000 Advanced Server
Cluster Configuration Guide
Introduction
This document defines the server cluster configurations supported by Hewlett-Packard for interconnection of
two HP Netserver LP 2000r servers and one or two HP Rack Storage/12 disk drive enclosure(s), with
Microsoft
±
Cluster Server software.
These configurations provide high server cluster availability and
minimize single points of failure (SPOFs).
A configuration certified and supported by both Hewlett-Packard
and Microsoft
±
is included, but any cluster configuration that conforms to the guidelines of this document
will be supported by Hewlett-Packard.
Deviations from the supported configurations can result in an
inoperative cluster, an operating cluster with degraded performance, or hidden SPOFs.
Therefore, deviations
are not supported.
For revision/update information on this document, refer to
Versions
on page 7.
Cluster Configuration Elements
This section identifies the hardware components, system software, network interfaces, and power distribution
arrangement required to build an operational server cluster supported by Hewlett-Packard.
The various
server cluster elements are listed below, and their associated configuration data is detailed in separate tables
and illustrations that follow.
±²
Server configuration
±²
Shared storage configuration
±²
Microsoft
±
and HP certified server configuration
±²
Intra-cluster (heartbeat) LAN configuration
±²
Client LAN configuration
±²
SCSI cabling and power distribution configuration
Server Configuration
Parameter
Specification
Server
Type
HP Netserver LP 2000r
Number of nodes
Two
Each node must be the same server type, but nodes may differ in their CPU clock
speeds and cache sizes, and amounts of main memory.
Clock speed
1.26 GHz
This certification covers any CPU speed within 500 MHz of the certified rate.
Number of CPUs
Two
BIOS
For CPU clock speeds up to 1 GHz, version range 4.06.16 RB to 4.06.21 RB
For CPU clock speeds of 1.26 GHz, version 4.06.03 RP or later
CPU cache
Any size
RAM
256 MB, minimum.
Must be HP.
10/21/02
1