HP D5970A hp netserver lt 6000r netraid-4m config guide — for Mic
HP D5970A - NetServer - LCII Manual
![]() |
View all HP D5970A manuals
Add to My Manuals
Save this manual to your list of manuals |
HP D5970A manual content summary:
- HP D5970A | hp netserver lt 6000r netraid-4m config guide — for Mic - Page 1
Windows NT® Server 4.0 Enterprise Edition Cluster Configuration Guide Introduction This document defines the server cluster configurations supported by Hewlett-Packard for interconnection of two HP Netserver LT 6000r servers and up to eight HP Rack Storage/12 disk drive enclosure(s), with Microsoft - HP D5970A | hp netserver lt 6000r netraid-4m config guide — for Mic - Page 2
Controller Driver Physical drive location Disk drives SCSI bus SCSI IDs System software Navigator CD-ROM Operating system Service pack Storage Configuration Parameter Controller Model Number of controllers BIOS Firmware Driver Specification HP NetRAID-4M Controller, Model D9161A, or D9351A One or - HP D5970A | hp netserver lt 6000r netraid-4m config guide — for Mic - Page 3
or multi-level Must be fault-tolerant Eight, maximum, per cluster Write cache disabled Clustering enabled Domain validation enabled Any HP drive supported by storage enclosure. Any combination of HP disk models is allowed in a diskset, on a SCSI channel, or in a cluster. Up to eight Rack Storage/12 - HP D5970A | hp netserver lt 6000r netraid-4m config guide — for Mic - Page 4
00, or later) Client LAN Configuration Parameter Network Connection NIC Quantity Model Driver Specification Any LAN One, minimum Any model that is on both the HP Tested Products List and the Microsoft® Hardware Compatibility List Vendor-supported driver If the NIC used is the same as that of the - HP D5970A | hp netserver lt 6000r netraid-4m config guide — for Mic - Page 5
lt6000rnt4m HP Netserver LT 6000r Cluster using HP Rack Storage/12 Cabling Diagram 1/28/02 5 - HP D5970A | hp netserver lt 6000r netraid-4m config guide — for Mic - Page 6
lt6000rnt4m Power Cabling to Separate Power Circuits 1/28/02 6 - HP D5970A | hp netserver lt 6000r netraid-4m config guide — for Mic - Page 7
Versions 18 January 2002 5 April 2001 lt6000rnt4m Added support for ultra3 models with latest NetRAID-4M firmware and driver. Changed heartbeat LAN requirement. Initial release © Copyright 2001, Hewlett-Packard Company 1/28/02 7
![](/manual_guide/products/hewlettpackard-lh3000r-hp-netserver-lt-6000r-netraid4m-config-guide-microsoft-nt-40-clusters-pdf-235k-1282002-44fe8b1/1.png)
1/28/02
1
HP Netserver LT 6000r
with
NetRAID-4M (HP Rack Storage/12)
Windows NT
°
Server 4.0 Enterprise Edition
Cluster Configuration Guide
Introduction
This document defines the server cluster configurations supported by Hewlett-Packard for interconnection of
two HP Netserver LT 6000r servers and up to eight HP Rack Storage/12 disk drive enclosure(s), with
Microsoft
Cluster Server software.
These configurations provide high server cluster availability and
minimize single points of failure (SPOFs).
A configuration certified and supported by both Hewlett-Packard
and Microsoft
is included, but any cluster configuration that conforms to the guidelines of this document
will be supported by Hewlett-Packard.
Deviations from the supported configurations can result in an
inoperative cluster, an operating cluster with degraded performance, or hidden SPOFs.
Therefore, deviations
are not supported.
For revision/update information on this document, refer to
Versions
on page
7
.
Cluster Configuration Elements
This section identifies the hardware components, system software, network interfaces, and power distribution
arrangement required to build an operational server cluster supported by Hewlett-Packard.
The various
server cluster elements are listed below and their associated configuration data is detailed in separate tables
and illustrations that follow.
•
Server configuration
•
Shared storage configuration
•
Microsoft
and HP certified server configuration
•
Intra-cluster (heartbeat) LAN configuration
•
Client LAN configuration
•
SCSI cabling and power distribution configuration
Server Configuration
Parameter
Specification
Server
Type
HP Netserver LT 6000r, Ultra2, or Ultra3 embedded SCSI models
Number of nodes
Two
Do not mix ultra2 and ultra3 models within a cluster.
Each node must be the
same server type, but may have different number of CPUs, clock speeds, and main
memory and cache sizes.
Clock speed
900 MHz
This certification covers any CPU rate within 500 MHz of the certified speed.
Number of CPUs
Two to six
BIOS
Ultra2 models—
Version range 4.06.33 PW to 4.06.43 PW
Ultra3 models—
Version 4.06.43 RL, or later
CPU cache
Any size
RAM
128 MB, minimum.
Must be HP.