HP D5970A HP Netserver LT6000r NetRAID-3Si Config Guide for Windows 2000 Adva
HP D5970A - NetServer - LCII Manual
View all HP D5970A manuals
Add to My Manuals
Save this manual to your list of manuals |
HP D5970A manual content summary:
- HP D5970A | HP Netserver LT6000r NetRAID-3Si Config Guide for Windows 2000 Adva - Page 1
HP NetServer LT 6000r with HP Rack Storage/12 Windows 2000 Advanced Server Cluster Configuration Guide 6 September 2000 (see Versions at the end of this document) Introduction This document defines the supported HP NetServer LT 6000r configurations with HP Rack Storage/12 and Microsoft Cluster - HP D5970A | HP Netserver LT6000r NetRAID-3Si Config Guide for Windows 2000 Adva - Page 2
CPU cache RAM No. of power supplies Local storage I/O slots: Default Boot Order M/S Certified Configuration HP NetServer LT 6000r 700 MHz 2 - 6 4.06.26 PW or later Any size 256 MB minimum. Must be HP. 2 standard, 3 required for redundancy See Local Storage below. Added cards may be installed in any - HP D5970A | HP Netserver LT6000r NetRAID-3Si Config Guide for Windows 2000 Adva - Page 3
SCSI cards for each cabinet 5 (fixed) 0 - 3, 8 - 15 (fixed) Any HP drive supported by storage enclosure including: HP 9.1 GB (7200 rpm) Low Profile Ultra2 SCSI Disk Module D6106A HP 9.1 GB (7200 rpm) Low Profile Ultra3 SCSI Disk Module P1217A HP 9.1 GB (10k rpm) Low Profile Ultra2 SCSI Disk Module - HP D5970A | HP Netserver LT6000r NetRAID-3Si Config Guide for Windows 2000 Adva - Page 4
LAN NIC must use the same driver as the Intra-cluster NIC. 1 minimum Shared Storage Cabling This part of the guide defines the allowable cabling configurations for clusters using the HP NetServer LT 6000r and HP Rack Storage/12. Only these cabling configurations and these cables are supported. 4 - HP D5970A | HP Netserver LT6000r NetRAID-3Si Config Guide for Windows 2000 Adva - Page 5
HP Microsoft Cluster Server with Rack Storage/12 5 - HP D5970A | HP Netserver LT6000r NetRAID-3Si Config Guide for Windows 2000 Adva - Page 6
Bu tt on Button Power Cabling to Separate Power Circuits 6 - HP D5970A | HP Netserver LT6000r NetRAID-3Si Config Guide for Windows 2000 Adva - Page 7
Versions 6 September 2000 Initial release. 7
1
HP NetServer LT 6000r
with
HP Rack Storage/12
Windows 2000 Advanced Server
Cluster Configuration Guide
6 September 2000
(see
Versions
at the end of this document)
Introduction
This document defines the supported HP NetServer LT 6000r configurations with HP Rack Storage/12 and
Microsoft Cluster Server.
These configurations minimize single points of failure (SPOF) and provide
extended availability.
The specific configuration certified and supported by both Hewlett-Packard and
Microsoft is defined, as are other guidelines to assist you in configuring your clustered NetServers.
This
guide is prescriptive; it describes the configurations supported by HP.
Any deviance to these
configurations can result in an inoperative cluster or an operating cluster with degraded performance,
hidden SPOFs, etc., and therefore will not be supported by HP.
What's Defined in Racked Cluster
Cluster
SPUs
Local and Shared Storage
Intra-cluster and Client LANs
Shared Storage Cabling
Cluster
Type of SPUs
HP NetServer LT 6000r
Each node must be the same model SPU, but may have different sizes of
main memory, cache, and different CPU clock speeds.
Number of nodes
2
Shared Storage
HP Rack Storage/12 with HP NetRAID-3Si controller and HP disks. See
Shared Storage
below.
LANs:
Client LAN
Any NIC that is HP and Microsoft approved.
See
Client LAN
below.
Intra-cluster
(Heartbeat) LAN
Embedded NIC with crossover cable. See
Intra-cluster LAN
below.