HP D5970A Installing Red Hat Linux on an HP Netserver
HP D5970A - NetServer - LCII Manual
 |
View all HP D5970A manuals
Add to My Manuals
Save this manual to your list of manuals |
HP D5970A manual content summary:
- HP D5970A | Installing Red Hat Linux on an HP Netserver - Page 1
from the HP web site as a reference to install an operating system, be sure to also check the HP web site for the latest available drivers. ©Copyright Hewlett KDE 2.1, GNOME 1.2 and a number of applications such as Samba and the TUX and apache web servers. Red Hat 7.1 supports up to 64GB of RAM. - HP D5970A | Installing Red Hat Linux on an HP Netserver - Page 2
update. (http://www.hp.com) Installing Red Hat Linux drivers are loaded, type: linux noprobe. 3. At the Language selection screen, select your language then press Next. 4. At the Keyboard Configuration screen, select your keyboard. Press Next. 5. At the Mouse Configuration screen, select your mouse - HP D5970A | Installing Red Hat Linux on an HP Netserver - Page 3
8. Disk partitioning will vary depending on the type of services the server will provide. The amount of swap space required also varies depending on the amount of RAM in the system. The following partitioning scheme - HP D5970A | Installing Red Hat Linux on an HP Netserver - Page 4
Next. C. At the "Graphic Configuration" screen, select the color depth and the screen resolution. Click on Test settings to ensure that the monitor will support the chosen configuration. You may also have to select between the two desktop environments: KDE and GNOME. If you set the login type to - HP D5970A | Installing Red Hat Linux on an HP Netserver - Page 5
. Congratulations! You just installed Red Hat Linux 7.1 Professional! On-Line Information and Software Sources Red Hat Inc., web access: http://www.redhat.com HP web access: http://www.hp.com HP Server Online Documentation CD (included with your system): includes all server documentation online
-
1 -
2 -
3 -
4 -
5
 |
 |
Red Hat Linux 7.1 Professional
Installation Guide for HP NetServers
NOTICE: The information in this document was last updated for the HP NetServer Navigator CD-ROM version
M.04.05. If you don't have the M.04.05 version CD-ROM and you're obtaining this document from the HP web
site as a reference to install an operating system, be sure to also check the HP web site for the latest available
drivers.
©Copyright Hewlett-Packard Company
(This document is only available in English.)
November 12, 2001 (Rev: 20011112)
Introduction
This document was created by Hewlett-Packard for the purpose of helping you install
Red Hat Linux 7.1 Professional on your HP NetServer, based on procedures tested by
HP. The objective of this document is to provide the information needed to achieve the
following tasks.
±²
Install Red Hat Linux 7.1 Professional from CD-ROM.
±²
Configure network settings.
Features
Red Hat Linux 7.1 Professional includes the 2.4.2 Linux kernel, XFree86 4.0.3, KDE 2.1,
GNOME 1.2 and a number of applications such as Samba and the TUX and apache web
servers. Red Hat 7.1 supports up to 64GB of RAM.
Requirements
Disk Space
: A full installation of Red Hat Linux 7.1 Professional requires around 2320
MB.
Hardware settings
: You will need to know the following information to complete the
installation:
±²
The monitor's resolution, color depth, and refresh rate.
±²
The display (graphics) adapter manufacturer and model number.
±²
The Ethernet card manufacturer, model number, IRQ, and I/O address.