HP ENVY 750-500 Optical Drive Replacement Instructions
HP ENVY 750-500 Manual
 |
View all HP ENVY 750-500 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP ENVY 750-500 manual content summary:
- HP ENVY 750-500 | Optical Drive Replacement Instructions - Page 1
Optical Drive Replacement Instructions 816853-001 Before you begin Observe the following requirements before removing and replacing the optical drive. WARNING: Never open the cover with the power cord - HP ENVY 750-500 | Optical Drive Replacement Instructions - Page 2
3. Locate the optical drive: 1. Optical drive 2. Hard drive 3. Memory modules 4. Disconnect the data and power cables from the rear of the drive (1), push the green release latch toward the center of the drive (2). 5. Depending on model: Pull the drive out through the front bezel. OR Rotate the - HP ENVY 750-500 | Optical Drive Replacement Instructions - Page 3
Replacing the optical drive 1. Before the new optical drive can be used, the release latch must be attached. Carefully align the holes on the release latch with the pins on the side of the optical drive. Press the entire release latch firmly to fasten the latch securely to the optical drive. Make - HP ENVY 750-500 | Optical Drive Replacement Instructions - Page 4
contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable
-
1 -
2 -
3 -
4
 |
 |
816853-001
1
Optical Drive Replacement Instructions
Before you begin
Observe the following requirements before removing and
replacing the optical drive.
WARNING
: Never open the cover with the power cord
attached or power applied. You might damage your
computer or be injured by the spinning fan blades.
WARNING
: Avoid touching sharp edges inside the
computer.
WARNING
: Keep your hands away from the moving fan.
WARNING
: Keep fingers and tools clear of the fan when
the power is applied.
CAUTION
: Static electricity can damage the electronic
components inside the computer. Discharge static
electricity by touching the metal cage of the computer
before touching any internal parts or electronic
components.
Tools needed
Phillips #2 screwdriver
Removing the optical drive
1.
Disconnect the power cord and all attached cables from
the back of the computer.
2.
Remove the access panel by loosening the Phillips
screw
(1)
, sliding the access panel back, and the lifting
it off the computer
(2)
.
816853-001