HP ENVY 750-500 Memory Module Replacement Instructions

HP ENVY 750-500 Manual

Get HP ENVY 750-500 PDF manuals and user guides View all HP ENVY 750-500 manuals
Add to My Manuals
Save this manual to your list of manuals

HP ENVY 750-500 manual content summary:

  • HP ENVY 750-500 | Memory Module Replacement Instructions - Page 1
    Memory Module Replacement Instructions 816855-001 Before you begin Observe the following are easily lost. Remove screws over a surface that enables you to retrieve them if they fall. Troubleshooting DDR3 DIMMs must meet the following requirements: ● 240-pin DDR3 DIMM ● DDR3-1600 SDRAM ●
  • HP ENVY 750-500 | Memory Module Replacement Instructions - Page 2
    2. Remove the access panel by loosening the Phillips screw (1), sliding the access panel back, and the lifting it off the computer (2). 3. Locate the memory modules: 1. Optical drive 2. Hard drive 3. Memory modules 4. Open both latches of the memory module socket (1), and then lift the module from
  • HP ENVY 750-500 | Memory Module Replacement Instructions - Page 3
    contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable
  • 1
  • 2
  • 3
816855-001
1
Memory Module Replacement
Instructions
Before you begin
Observe the following requirements before removing and
replacing memory.
WARNING
: Never open the cover with the power cord
attached or power applied. You might damage your
computer or be injured by the spinning fan blades.
WARNING
: Avoid touching sharp edges in the computer.
WARNING
: Keep your hands and tools away from the
moving fan.
CAUTION
: Static electricity can damage the electronic
components inside the computer. Discharge static electricity
by touching the metal cage of the computer before touching
any internal parts or electronic components.
Tools needed
Phillips #2 screwdriver
Small screws are easily lost. Remove screws over a surface
that enables you to retrieve them if they fall.
Troubleshooting
If the computer displays a memory error after you have
turned it back on, turn the computer off and unplug the
power cord, then open up the memory compartment and
make sure the memory card is firmly seated. To install it
correctly, make sure it is inserted all the way into the slot,
and then push down on it to snap it into place.
Memory compatibility
The computer uses either DDR4-2133 or DDR3-1600
DIMMs (dual-inline memory modules).
DDR4 DIMMs must meet the following requirements:
●
240-pin DDR4 DIMM
●
DDR4-2133 SDRAM
●
Unbuffered, non-ECC (64-bit) DIMMs
●
1.5 V memory only
●
32 GB maximum installable memory
DDR3 DIMMs must meet the following requirements:
●
240-pin DDR3 DIMM
●
DDR3-1600 SDRAM
●
Unbuffered, non-ECC (64-bit) DIMMs
●
1.5 V memory only
●
32 GB maximum installable memory
Because the memory uses dual channels, you must use the
same memory modules type for both sockets.
NOTE
: The actual memory transfer speed might vary
based on the processor used in your computer.
NOTE
: Memory performance might vary due to different
system configurations.
Removing the memory module
1.
Disconnect the power cord and all attached cables
from the back of the computer.

816855-001