HP Integrity Superdome SX2000 Safety and Regulatory Information, Eighth Editio
HP Integrity Superdome SX2000 Manual
 |
View all HP Integrity Superdome SX2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Integrity Superdome SX2000 manual content summary:
- HP Integrity Superdome SX2000 | Safety and Regulatory Information, Eighth Editio - Page 1
Safety and Regulatory Information HP Superdome Family Eighth Edition Manufacturing Part Number : A5201-96055-en March 2007 - HP Integrity Superdome SX2000 | Safety and Regulatory Information, Eighth Editio - Page 2
to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors - HP Integrity Superdome SX2000 | Safety and Regulatory Information, Eighth Editio - Page 3
highlights supplemental information. Safety in Material Handling WARNING Do not lift the cabinet manually. To avoid physical injury you must use a mechanical lifting device. WARNING Do removal of a single input source. Trained service personnel must follow the service guidelines. Chapter 1 3 - HP Integrity Superdome SX2000 | Safety and Regulatory Information, Eighth Editio - Page 4
onto the ramps. When removing the equipment from the shipping pallet, follow the guidelines specified in the Installation Procedures section of the appropriate equipment guides. WARNING Do not attempt to move the cabinet, either packed or unpacked, up or down an incline of more than 15ο. IOX Only - HP Integrity Superdome SX2000 | Safety and Regulatory Information, Eighth Editio - Page 5
local city office, your household waste disposal service or the shop where you purchased the product or disposed of in California. Refer to the product user documentation to determine if this product contains batteries, and Mark applies to HP-branded Enterprise Storage and Server products. Additional - HP Integrity Superdome SX2000 | Safety and Regulatory Information, Eighth Editio - Page 6
B) has specified that the following notice be brought to the attention of the users of this product. NOTE This equipment has been tested and found to comply if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of - HP Integrity Superdome SX2000 | Safety and Regulatory Information, Eighth Editio - Page 7
: This is a Class A IT (Information Technology) Product. If this product is used in a domestic environment, radio frequency disturbance may occur, in which case the user may be required to take corrective actions. The EMC label is in the form shown in Figure 1-1. The eight # signs represent an eight - HP Integrity Superdome SX2000 | Safety and Regulatory Information, Eighth Editio - Page 8
High Leakage Current WARNING Do not connect the supply before establishing an adequate ground (earth) connection. Installation Conditions See installation instructions before connecting this equipment to the input supply. WARNING The equipment must be provided with a proper AC protective earth (PE - HP Integrity Superdome SX2000 | Safety and Regulatory Information, Eighth Editio - Page 9
Safety and Regulatory Information Disconnect Devices NOTE Specific countries require a derating factor for the wire size when running multiple conductors in the same power cord. It is recommended to use only power cord conductors sized for this derating factor. Table 1-1 Recommended Wire Sizes - HP Integrity Superdome SX2000 | Safety and Regulatory Information, Eighth Editio - Page 10
power is removed from both PDCA before removing fuses. Fuse Warnings Superdome Only: WARNING Disconnect power before changing fuse. CAUTION For continued Dispose of used batteries according to the manufacturer's instructions and local disposal requirements. IMPORTANT Switzerland: Annex 4.10 - HP Integrity Superdome SX2000 | Safety and Regulatory Information, Eighth Editio - Page 11
Australian C-Tick Label Figure 1-3 Safety and Regulatory Information Australian C-Tick Label International Symbols (IEC335-1) Figure 1-4 Four Wire Connection 3 Protective earth, 3-phase AC Figure 1-5 Five Wire Connection 3N Protective earth, 3-phase AC plus neutral return Chapter 1 11 - HP Integrity Superdome SX2000 | Safety and Regulatory Information, Eighth Editio - Page 12
. In the U.S.A., the DVD is certified as a Class 1 laser product conforming to the requirements contained in the Department of Health and Human Services (DHHS) regulation 21 CFR, Subchapter J. The certification is indicated by a label on the DVD housing. Outside the U.S.A., the DVD is certified as - HP Integrity Superdome SX2000 | Safety and Regulatory Information, Eighth Editio - Page 13
Associated Documents Figure 1-6 Declaration of Conformity - Page 1 Safety and Regulatory Information Associated Documents Chapter 1 13 - HP Integrity Superdome SX2000 | Safety and Regulatory Information, Eighth Editio - Page 14
Safety and Regulatory Information Associated Documents Figure 1-7 Declaration of Conformity - Page 2 14 Chapter 1 - HP Integrity Superdome SX2000 | Safety and Regulatory Information, Eighth Editio - Page 15
Figure 1-8 Declaration of Similarity Safety and Regulatory Information Associated Documents Chapter 1 15 - HP Integrity Superdome SX2000 | Safety and Regulatory Information, Eighth Editio - Page 16
Safety and Regulatory Information Associated Documents Figure 1-9 I/O Expansion Cabinet Declaration of Conformity 16 Chapter 1
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
 |
 |
Safety and Regulatory Information
HP Superdome Family
Eighth Edition
Manufacturing Part Number : A5201-96055-en
March 2007