HP Integrity rx6600 Console Quick Start - HP Integrity rx3600 and rx6600 Serve

MPN: AB463-9006A

AB463-9006A

1

Console Quick Start

Use this console quick start for a server that is set up and ready to connect to a host console. This material

can also be found in the

HP Integrity rx3600 and HP Integrity rx6600 Installation Guides

or the

HP Integrity

rx3600 and rx6600 Integrated Lights-Out 2 Management Processor Operations Guide

.

To connect the console, use one or more of the following ports:

•

RS-232 serial port. Use this port to access the iLO 2 MP through the serial.

•

iLO 2 MP LAN port. Use this port to access the iLO 2 MP through the LAN.

•

VGA port. Use this port to access a graphics console. (You cannot access the iLO 2 MP using this port.)

Physical Access Methods

Figure 1 shows ports, connection methods, and required connection components.

Figure 1

Server Rear Ports

IMPORTANT

Once you are physically connected, the next step is to configure the console. For information on

configuring the console, see the

HP Integrity rx3600 and rx6600 Installation Guides

at:

and search for your server product number.

HP Integrity rx3600 / rx6600 Servers

RS-232 Serial Port

(RS-232 female-to-female cable)

Connected to emulation terminal

device (PC, laptop, or ASCII terminal)

iLO 2 MP LAN Port

(10/100 LAN cable)

The iLO 2 MP LAN port requires a

separate IP address from the port

used by the operating system.

Obtain the MAC address to the

UCIO board and not the MAC

address to the server core LAN card.

USB 2.0 Ports

(any USB device)

VGA Port (optional)

(VGA cable)

No iLO 2 MP access; EFI only.

General Use Serial Port

(printers, etc.)