HP LH4r HP Netserver LT 6000r with Model FC60 Config Guide for Windows NT4.0
HP LH4r - NetServer - 256 MB RAM Manual
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
HP LH4r manual content summary:
- HP LH4r | HP Netserver LT 6000r with Model FC60 Config Guide for Windows NT4.0 - Page 1
Store E Disk Array FC60 with HP NetServer HP LT6000r Cluster Configuration Guide 15 May 2000 Introduction This document defines a supported cluster using the HP SureStore E Disk Array FC60 and the HP NetServer LT6000r and Microsoft Cluster Server. This configuration eliminates single points of - HP LH4r | HP Netserver LT 6000r with Model FC60 Config Guide for Windows NT4.0 - Page 2
storage HP NetServer LT6000r 550 MHz 2-6 Release 4 1 MB 256MB. Must be HP. 3 See Local Storage below. Storage Local Controller Cabinets (Physical drive location) Disk drives (hot swap or fixed) SCSI bus SCSI Ids Shared HP SureStore E Disk Array FC60 Host Bus Adapter Model No. of HBAs Driver RAID - HP LH4r | HP Netserver LT 6000r with Model FC60 Config Guide for Windows NT4.0 - Page 3
(need two per connection) Copper (Server to Hub only): 3 meter D6978A 5 meter D6979A 10 meter D7080A Copper cables include 2 copper GBICs HP D6976A 6-port fibre channel 2 LANs LAN connection NIC: Model Driver No. of NICs Intra-cluster (Heartbeat) LAN HP D5954A crossover cable or any equivalent - HP LH4r | HP Netserver LT 6000r with Model FC60 Config Guide for Windows NT4.0 - Page 4
Shared Storage Cabling Two hubs used for HA configuration (same data center), 2 NT hosts, up to 4 FC60s HP LT6000r HP LT6000r HP D8602A HBAs. GBIC are required. Optical or Copper Optical or Copper Optical or Copper Optical or Copper D6976A D6976A Hub always requires a GBIC Optical Optical
1
HP Sure Store E Disk Array FC60
with
HP NetServer HP LT6000r
Cluster Configuration Guide
15 May 2000
Introduction
This document defines a supported cluster using the HP SureStore E Disk Array FC60 and the HP NetServer
LT6000r and Microsoft Cluster Server. This configuration eliminates single points of failure (SPOF), provides
maximum availability, and has been certified by Hewlett-Packard and Microsoft.
This guide is prescriptive; it
describes a configuration supported by HP.
Any deviance to this configuration can result in an inoperative
cluster or an operating cluster with degraded performance, hidden SPOFs, etc., and therefore will not be
supported by HP.
For all supported configurations, refer to the HP SureStore E Disk Array FC60 for Windows
Configuration Guide.
What's Defined in a Cluster
•
Cluster
•
SPUs
•
Local and Shared Storage
•
Intra-cluster and Client LANs
•
Shared Storage Cabling
Cluster
Type of SPUs
HP NetServer LT6000r
Each node must be the same model SPU, but may have different clock
speeds, main memory sizes, cache sizes, and number of CPUs (2, 3, 4, 5 or
6).
Number of nodes
2
Shared Storage
HP SureStore E Disk Array FC60, and a HP D8602A HBA in the server.
See
Shared Storage
below.
LANs:
Client LAN
Any that is HP and Microsoft approved.
See
Client LAN
below.
Intra-cluster
(Heartbeat) LAN
HP D5013A/B
(10/100TX PCI) with crossover cable. See
Intra-cluster LAN
below.
Power source
Direct from power mains, power conditioner or uninterruptible power
supply (UPS) using any power conditioner or UPS.
System software:
Navigator version
L.16.05 or later
Operating System
Microsoft Windows NT Server 4.0, Enterprise Edition with Service Pack
SP5 or later