HP LH4r HP Netserver LXr Pro8 Surestore E Config Guide for Windows NT4.0 Clus
HP LH4r - NetServer - 256 MB RAM Manual
 |
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
HP LH4r manual content summary:
- HP LH4r | HP Netserver LXr Pro8 Surestore E Config Guide for Windows NT4.0 Clus - Page 1
the supported HP NetServer LXr Pro8 and A3700AB HP SureStore E 12H Disk Array configurations for Microsoft Cluster Server. These configurations minimize single points of failure, provide maximum availability, and have been certified by Hewlett-Packard and Microsoft. This guide is prescriptive - HP LH4r | HP Netserver LXr Pro8 Surestore E Config Guide for Windows NT4.0 Clus - Page 2
Clock speed No. of CPUs BIOS CPU cache RAM No. of power supplies Local storage I/O slots: LANs LAN connection NIC: Model Driver No. of NICs SPU I\O slot Local Storage Physical drive location Disk drives Controller SCSI bus HP NetServer LXr Pro8 200 MHz. 2-8 (at least 2 are required for each node - HP LH4r | HP Netserver LXr Pro8 Surestore E Config Guide for Windows NT4.0 Clus - Page 3
Firmware RAID level (internal) Logical disks Hot spare SCSI ID Disk Array Storage Model No. of cabinets Disk modules: Power supply AutoRAID Manager (ARM) Cabling Terminator HP A5252B Wide Differential SCSI Adapter. 1-3 per NetServer. "Adaptec AHA-294X/AHA-394X/AIC-78XX SCSI Controller" driver in - HP LH4r | HP Netserver LXr Pro8 Surestore E Config Guide for Windows NT4.0 Clus - Page 4
Shared Storage Cabling This part of the guide defines the allowable cabling configurations for HP LXr Pro8 NetServer clusters using the HP SureStore E 12H Disk Array. Only these cabling configurations and cables are supported. These diagrams show single and daisy-chained configurations. A5252B SCSI - HP LH4r | HP Netserver LXr Pro8 Surestore E Config Guide for Windows NT4.0 Clus - Page 5
A5252B SCSI HBA HP Microsoft Cluster Server and two daisy-chained HP SureStore E 12H Disk Array 5 - HP LH4r | HP Netserver LXr Pro8 Surestore E Config Guide for Windows NT4.0 Clus - Page 6
Version History 10 October 1999 1 August 1998 Updated the shared storage model name from AutoRAID 12H to SureStore E 12H throughout, and changed the shared storage Host Bus Adapter model number from HP A5252A to A5252B. Initial release 6
-
1 -
2 -
3 -
4 -
5 -
6
 |
 |
HP NetServer LXr Pro8
with
A3700AB HP SureStore E 12H Disk Array
Cluster Configuration Guide
10 October 1999
Introduction
This document defines the supported HP NetServer LXr Pro8 and A3700AB HP SureStore E 12H Disk Array
configurations for Microsoft Cluster Server.
These configurations minimize single points of failure, provide
maximum availability, and have been certified by Hewlett-Packard and Microsoft.
This guide is prescriptive; it
describes the configurations supported by HP.
Any configuration not expressly allowed by this guide will not
be supported by HP.
What’s Defined
•
Cluster
•
SPUs
•
LANs
•
Local Storage
•
Shared Storage
•
Shared Storage Cabling
Cluster
Type of SPUs
HP NetServer LXr Pro8
Each node must be the same model SPU, but may have different size main
memory and number of CPUs.
Number of nodes
2
Shared Storage
See
Shared Storage
below.
LANs:
Client
See
Client LAN
below.
Intra-cluster
See
Intra-cluster LAN
below.
Power source
Direct from power mains, power conditioner or uninterruptible power
supply (UPS) using any power conditioner or UPS.
System software:
Navigator version
G.01.45 or later
Operating System
Microsoft Windows NT Server 4.0, Enterprise Edition
Service pack
SP3 and hotfix "clusfixi", or later