HP NetServer LH 3000 Installing Banyan VINES on an HP Netserver

HP NetServer LH 3000 Manual

Get HP NetServer LH 3000 PDF manuals and user guides View all HP NetServer LH 3000 manuals
Add to My Manuals
Save this manual to your list of manuals

HP NetServer LH 3000 manual content summary:

  • HP NetServer LH 3000 | Installing Banyan VINES on an HP Netserver - Page 1
    E 30, E 40, E 45, LC Plus, LC II, LC 3, LD Pro, LH, LH Plus, LH Pro, LH II, LH 3, LS, LX Pro, LXe Pro, and LXr Pro Banyan VINES Network Installation Guide NOTICE: The information in this document was last updated for the HP NetServer Navigator CD-ROM version L.11.00. If you don't have the L.11.00
  • HP NetServer LH 3000 | Installing Banyan VINES on an HP Netserver - Page 2
    Interface Cards (NICs) HP Bundled NICS Not Supported On VINES Section 2. Installation Guide Booting from the Embedded Scsi Controller Video Bios Shadowing Setting Advanced Features EIDE/ATAPI CDROM drives are not supported VINES support for SCSI controllers VINES support for Disk Array Controllers
  • HP NetServer LH 3000 | Installing Banyan VINES on an HP Netserver - Page 3
    utility on the NetServer Navigator CD-ROM before installing any system software. When using HP NetRAID, HP recommends RAID level 5 for general office environments Determining the Number of Disk Drives For acceptable server performance, HP recommends a minimum of two hard drives per controller
  • HP NetServer LH 3000 | Installing Banyan VINES on an HP Netserver - Page 4
    (NICs) that are bundled in some HP NetServer models do not have drivers for Banyan VINES. Consult Banyan's hardware compatability guide for a supported NIC. Section 2. Installation Guide Booting from the Embedded SCSI Controller The system boots from the drive with the lowest SCSI address. If you
  • HP NetServer LH 3000 | Installing Banyan VINES on an HP Netserver - Page 5
    HP NetServer Navigator CD-ROM, run the ECU in manual mode. C. Run the ECU in manual mode from the HP NetServer Navigator Utility menu. D. Run the ECU in manual mode from the utility partition. E. Run the ECU in manual mode from the ECU diskette that you created using the HP NetServer Navigator CD
  • HP NetServer LH 3000 | Installing Banyan VINES on an HP Netserver - Page 6
    VINES 6.0 (and later) supports the HP NetRAID Adapter PCI DAC with a supplemental driver package. HP has included the HP NetRAID driver on the HP NetServer Navigator CD. The driver diskette can be created from the HP NetServer Navigator's "Diskette Library" feature. The HP NetRAID driver is not
  • HP NetServer LH 3000 | Installing Banyan VINES on an HP Netserver - Page 7
    may occur. For instructions on how to load a third-party driver package on your VINES 6.0 server see your Banyan Server Installation Guide. VINES 6.0 (and HP Internet (World-Wide-Web) site: www.hp.com/netserver HP Support FTP site: ftp://ftp.hp.com/pub/servers/ HP NetServer Online Documentation CD
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
1
HP NetServer E 30, E 40, E 45, LC Plus,
LC II, LC 3, LD Pro, LH, LH Plus, LH
Pro, LH II, LH 3, LS, LX Pro, LXe Pro,
and LXr Pro
Banyan VINES Network Installation
Guide
NOTICE: The information in this document was last updated for the HP NetServer Navigator CD-ROM version
L.11.00. If you don't have the L.11.00 version CD-ROM and you're obtaining this document from the HP NetServer
web site as a reference to install an operating system, be sure to also check the HP NetServer web site for the latest
available drivers.
©Copyright Hewlett-Packard Company
June 29, 1997
Introduction
Installing VINES 5.54, 6.0, or 7.0 on the NetServer involves many of the standard
procedures covered in the Banyan documentation as well as the general HP NetServer
documentation.
This document presents the most important information that you need to install VINES.
The first part of this document is a list of helpful tips on hardware installation, the second
part is a step-by-step installation guide.
It may be useful to look over the information in this guide before you begin using the
standard HP and Banyan documents.
Then, as you go through the installation process,
you can refer to this guide as necessary.
NOTE: Hewlett-Packard has more than one Disk Array Controller (DAC) for the
NetServer product family.
In this document the term "HP Disk Array
Controllers" refers to the EISA and PCI HP Disk Array Controller models
C3609A and C3610A, respectively.
The term "HP NetRAID" refers to the HP
NetRAID
and NetRAID-1 PCI DAC models D4943A and D4992A, respectively.
The Hewlett-Packard Company does not support the use of VINES 5.54 (and
earlier) on the HP NetServer E 30, E 40, E 45, LC II, LC 3, LD Pro, LH, LH Plus,
LH Pro, LH II, LH 3, LS, LX Pro, LXe Pro, and Lxr Pro.
The Hewlett-Packard Company does not support the use of VINES 6.0 (and later)
on the HP NetServer E 30, E 40, and E 45.