HP P5389A Installing Novell NetWare on an HP Netserver

HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Manual

Get HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade PDF manuals and user guides
UPC - 088698513354
View all HP P5389A manuals
Add to My Manuals
Save this manual to your list of manuals

HP P5389A manual content summary:

  • HP P5389A | Installing Novell NetWare on an HP Netserver - Page 1
    on the HP NetServer NetWare 4.2 Installation NetWare 5.1 or NetWare Small Business Suite 5/5.1 Installation Section 5. General NetWare Installation Tips Tip #1. Using the REGISTER MEMORY Command to allow NetWare 4.xx to Use All System Memory Tip #2. Installing NetWare 4.2 on a 4GB hard disk drive
  • HP P5389A | Installing Novell NetWare on an HP Netserver - Page 2
    drivers. To use this utility, first boot your HP NetServer using the Navigator CD. Once at the NetServer Navigator Main Menu, select the Configure the Server option. From the NetServer Navigator Mode Selection for Configuring the Server menu select Guided Setup. Follow the on-screen instructions
  • HP P5389A | Installing Novell NetWare on an HP Netserver - Page 3
    must first install a CD-ROM drive and driver in the DOS environment by using the driver diskettes you created using the HP NetServer Navigator CD. NOTE: DOS CD-ROM drivers are available on the NOS Drivers Diskette in the \Cdromdrv\IDEDOS directory. 1. Boot your HP NetServer using an MS DOS bootable
  • HP P5389A | Installing Novell NetWare on an HP Netserver - Page 4
    reinstall remaining memory. NOTE: At least a 250 MB DOS partition must already exist on your hard drive and your CD-ROM drive should be accessible. For detailed instructions refer to Installing the CDROM Drive in DOS with FDATACD.SYS and MSCDEX.EXE. 1. Remove the HP NetServer Navigator CD
  • HP P5389A | Installing Novell NetWare on an HP Netserver - Page 5
    = 2000 Set Maximum Packet Receive Buffers = 15000 Save and continue by pressing F10. 15. Select No when prompted to Add commands to AUTOEXEC.BAT to load SERVER.EXE. NOTE: You may receive the following message: Install found the following hardware but found more than one driver supporting this
  • HP P5389A | Installing Novell NetWare on an HP Netserver - Page 6
    in your system. Also do the same for any Network Adapters. NOTE: HP NetServer LP 2000r and LP 1000r systems require that the second instance of the IDEATA.HAM driver be deleted. Highlight the second instance of the IDEATA.HAM driver, press delete, and continue with the installation. 17. If there is
  • HP P5389A | Installing Novell NetWare on an HP Netserver - Page 7
    33. Insert NetWare License diskette into the floppy drive and press F3 and then Enter. 34. program will proceed to copy NetWare files to your HP NetServer. Wait till next prompt. 36. If you wish support pack from Novell. This can be downloaded from: http://support.novell.com Installing the SMP driver
  • HP P5389A | Installing Novell NetWare on an HP Netserver - Page 8
    not use the mega4_xx.ham driver in this case). - You wish to use the Hewlett-Packard NetRAID Config for NetWare or the HewlettPackard NetRAID Monitor for NetWare utility. NOTE: Booting from the HP NetRAID-1si or HP NetRAID-3si using the I20 driver is not supported at this time. For more information
  • HP P5389A | Installing Novell NetWare on an HP Netserver - Page 9
    on your hard drive and your CD-ROM drive should be accessible. For detailed instructions, refer back to the section Installing the CD-ROM Drive in DOS with FDATACD.SYS and MSCDEX.EXE. 1. Remove the HP NetServer Navigator CD-ROM and any floppy diskettes from the A: drive and boot your server into DOS
  • HP P5389A | Installing Novell NetWare on an HP Netserver - Page 10
    one CPU, ensure that MPS14 appears in the Platform Specific Module. Hot Plug support module may optionally display depending on whether or not your HP NetServer supports Hot Plug PCI. The installation program for NetWare will load all drivers placed in the NWUPDATE directory and match appropriate
  • HP P5389A | Installing Novell NetWare on an HP Netserver - Page 11
    HP NetServer. Wait till next prompt. 21. Enter the Server to configure the Domain Name Service, do so here. If Server Object, and the administrator password and click Next. 31. Review NDS and click Next. 32. Insert NetWare License diskette into the floppy drive support pack from Novell. This can be
  • HP P5389A | Installing Novell NetWare on an HP Netserver - Page 12
    driver in this case). - You wish to use the Hewlett-Packard NetRAID Config for NetWare or the HewlettPackard NetRAID Monitor for NetWare utility. 5. Use the NetRAID Express Tools (version B.02.02 or later) included with your adapter or on the NetServer Navigator CD to set the HP NetRAID-1Si or HP
  • HP P5389A | Installing Novell NetWare on an HP Netserver - Page 13
    ://support.novell.com and follow the instructions in the .TXT file (included with the self-extracting file) to install NetWare. Section 6. Online Information and Software Sources Novell Network Internet site: http://www.novell.com Hewlett-Packard Internet site: http://www.hp.com HP NetServer Online
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
Hewlett-Packard NetServer
Novell NetWare Installation Guide
NOTICE: The information in this document was last updated for the HP NetServer Navigator CD-ROM version M.04.05.
If you don't have the M.04.05 version CD-ROM and you're obtaining this document from the HP web site as a reference
to install an operating system, be sure to also check the HP web site for the latest available drivers.
©Copyright Hewlett-Packard Company
October 8, 2001
Objective
The intent of this document is to provide you with key information required for completing the
installation of NetWare on an HP NetServer. Installation requires familiarity with both DOS and
NetWare. Please refer to Novell's NetWare Installation Guide for detailed step-by-step
instructions.
This document only details how to create a DOS partition and install Network, SCSI, and Disk
Array drivers.
Table of Content
Section 1. Novell NetWare Installation Overview
Section 2. Automated Installation via the HP NetServer Navigator CD
Section 3. Creating the Drivers Diskette and Installing the IDE CD-ROM Drivers
Creating the Drivers Diskette
Installing the IDE Drive with FDATACD. SYS and MSCDEX.EXE
Section 4. Installing NetWare on the HP NetServer
NetWare 4.2 Installation
NetWare 5.1 or NetWare Small Business Suite 5/5.1 Installation
Section 5. General NetWare Installation Tips
Tip #1. Using the REGISTER MEMORY Command to allow NetWare 4.xx to Use All
System Memory
Tip #2. Installing NetWare 4.2 on a 4GB hard disk drive