HP P6000 HP StorageWorks Disk enclosure I/O module replacement instructions (5
HP P6000 Manual
View all HP P6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP P6000 manual content summary:
- HP P6000 | HP StorageWorks Disk enclosure I/O module replacement instructions (5 - Page 1
hp.com/support/ manuals, and select your product. The information contained herein is subject to change without notice. The only warranties for HP products and services removed and replaced without having to power the system down. NOTE: All disk enclosures will ship with two I/O modules installed - HP P6000 | HP StorageWorks Disk enclosure I/O module replacement instructions (5 - Page 2
disk enclosure. See Figure 1 for the locations. 1. I/O module A Figure 1 I/O module locations 2. I/O module B Verifying component failure Before replacing the module, check the following and confirm with HP support that it has failed: • Analyze any failure messages received. HP fault monitoring - HP P6000 | HP StorageWorks Disk enclosure I/O module replacement instructions (5 - Page 3
: • See Table 1 on page 2 and check for healthy LED patterns. Returning the failed component Follow instructions shipped with the replacement part. Additional information HP support: http://www.hp.com/support HP resources (white papers and support documents): http:// www.hp.com/support/manuals Page
HP StorageWorks
Disk enclosure I/O module
replacement instructions
This document details the procedures for replacing a
failed I/O module in an HP enclosure.
© Copyright 2009 Hewlett-Packard Development Company, L.P.
First edition: June 2009
The information in this document is subject to change without notice.
Printed in the US
www.hp.com
*504221-001*
About this document
For the latest documentation, go to
h
t
tp://w
w
w
.hp
.co
m/su
ppo
r
t/
man
uals
, and select your product.
The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the
express warranty statements accompanying such products and services.
Nothing herein should be construed as constituting an additional
warranty. HP shall not be liable for technical or editorial errors or
omissions contained herein.
WARRANTY STATEMENT: To obtain a copy of the warranty for this
product, see the warranty information website:
h
t
tp://w
w
w
.hp
.co
m/
go/s
t
o
r
age
w
ar
r
an
t
y
Before you begin
Observe the following precautions when replacing a module.
CAUTION:
•
Removing a module significantly changes air flow within the
enclosure. All enclosure bays must be populated with a module
or blanking panel for the enclosure to cool properly. If a
module fails, leave it in place in the enclosure until a new
module is available to install.
•
Parts can be damaged by electrostatic discharge. Use proper
anti-static protection. Refer to the documentation that shipped
with your system for additional information.
NOTE:
Port-colored (purple) latches on components mean the
component is hot-swappable. It can be removed and replaced
without having to power the system down.
NOTE:
All disk enclosures will ship with two I/O modules installed and
ready for use. However, in some of the configurations, they will
only cable up and use one of them. In those environments, the
I/O module is not hot-pluggable. An I/O module is only
hot-pluggable when both are in use but one has failed or is
failing.
NOTE:
Illustrations in this document may show modules or a chassis
that differ from your device. However, replacement procedures
are the same for all chassis that use this component.
Page 1