HP Pavilion 27-r000 Optical Drive Replacement Instructions 1
HP Pavilion 27-r000 Manual
 |
View all HP Pavilion 27-r000 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Pavilion 27-r000 manual content summary:
- HP Pavilion 27-r000 | Optical Drive Replacement Instructions 1 - Page 1
Optical Drive Replacement Instructions 925495-001 Before you begin Observe the following requirements before removing and replacing the optical drive. WARNING: To reduce the risk of serious injury or - HP Pavilion 27-r000 | Optical Drive Replacement Instructions 1 - Page 2
3. Remove the access panel by removing the two screws (1), sliding the access panel back (2), and then rotating it down and off the computer (3). 4. Locate the optical drive: 1. Top hard drives 2. Optical drive 3. Side hard drives 5. To remove an optical drive insert: Push the release latch toward - HP Pavilion 27-r000 | Optical Drive Replacement Instructions 1 - Page 3
contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable
-
1 -
2 -
3
 |
 |
925495-001
1
Optical Drive Replacement Instructions
Before you begin
Observe the following requirements before removing and
replacing the optical drive.
WARNING
: To reduce the risk of serious injury or
damage to the equipment, do not open the chassis cover of
any unit with a 750W power supply. To determine if you
have a 300W, 500W or 750W power supply, refer to the
label on the rear of the computer.
CAUTION
: Never open the cover with the power cord
attached or power applied. You might damage your
computer or be injured by the spinning fan blades.
CAUTION
: Avoid touching sharp edges inside the
computer.
NOTICE
: Static electricity can damage the electronic
components inside the computer. Discharge static
electricity by touching the metal cage of the computer
before touching any internal parts or electronic
components.
Tools needed
Phillips #2 screwdriver
Small screws are easily lost. Remove screws over a
surface that enables you to retrieve them if they fall.
NOTE
: Computer appearance and features may vary by
model.
Removing the optical drive
1.
Press the power button to turn off the computer.
2.
Disconnect the power cord and all attached cables
from the back of the computer.
925495-001