HP Presario SG3200 Upgrade and Service Guide
HP Presario SG3200 - Desktop PC Manual
View all HP Presario SG3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Presario SG3200 manual content summary:
- HP Presario SG3200 | Upgrade and Service Guide - Page 1
Upgrading and Servicing Guide - HP Presario SG3200 | Upgrade and Service Guide - Page 2
forth in the express statements accompanying such products and services. Nothing herein should be construed as constituting an additional of Microsoft Corporation in the United States and/or other countries/regions. HP supports lawful use of technology and does not endorse or encourage the use of our - HP Presario SG3200 | Upgrade and Service Guide - Page 3
Table of Contents Upgrading and Servicing Guide 1 Safety Information 1 Opening and Closing the Computer 1 Preparing the Computer 2 Before Opening the Computer 2 After Closing the Computer 3 Removing the Side Panel 3 Replacing the Side - HP Presario SG3200 | Upgrade and Service Guide - Page 4
iv Upgrading and Servicing Guide - HP Presario SG3200 | Upgrade and Service Guide - Page 5
connecting your system to the electrical power system, please read "Safety Information" in the Limited Warranty and Support Guide. This Upgrading and Servicing Guide provides instructions for removing and replacing hardware components of your computer. Opening and Closing the Computer Upgrading and - HP Presario SG3200 | Upgrade and Service Guide - Page 6
so that you can safely handle it and the components. Before attempting to upgrade or service the computer, read the following items: 1 These procedures assume familiarity with the general terminology of static electricity by briefly touching a grounded metal object. 2 Upgrading and Servicing Guide - HP Presario SG3200 | Upgrade and Service Guide - Page 7
to slide the panel back about 2.5 centimeters (1 inch), and then lift it off the chassis. WARNING: Beware of sharp edges inside the chassis. Upgrading and Servicing Guide 3 - HP Presario SG3200 | Upgrade and Service Guide - Page 8
tabs away from the outside edge of the chassis. 2 Swing the front panel (to the left) away from the chassis to remove it. 4 Upgrading and Servicing Guide - HP Presario SG3200 | Upgrade and Service Guide - Page 9
right side of the front panel into the three holes on the right side of the chassis until the panel snaps into place. Upgrading and Servicing Guide 5 - HP Presario SG3200 | Upgrade and Service Guide - Page 10
Media Drive bay (select models only) C Primary hard disk drive D Memory card reader (select models only) E Front connector panel (no replacement instructions) F Space for a second hard disk drive (a second hard drive must be purchased separately) NOTE: The connectors and components of your chassis - HP Presario SG3200 | Upgrade and Service Guide - Page 11
the chassis. NOTE: The following figure shows both optical drives. Your chassis may include one or two optical drives, depending on your model. Upgrading and Servicing Guide 7 - HP Presario SG3200 | Upgrade and Service Guide - Page 12
the knockout plate slot (B), and then rotate the screwdriver to break the knockout plate out of the front panel. Discard the knockout plate. B B 8 Upgrading and Servicing Guide - HP Presario SG3200 | Upgrade and Service Guide - Page 13
the data cables are not connected correctly, the computer will be unable to locate the hard disk drives and data may be lost. Upgrading and Servicing Guide 9 - HP Presario SG3200 | Upgrade and Service Guide - Page 14
the two screws on the side of the drive, and then slide the drive partway out of the front of the chassis. 10 Upgrading and Servicing Guide - HP Presario SG3200 | Upgrade and Service Guide - Page 15
it. See "Removing the Primary Hard Disk Drive" on page 10. 2 Slide the hard disk drive partway into the front of the chassis. Upgrading and Servicing Guide 11 - HP Presario SG3200 | Upgrade and Service Guide - Page 16
the two screws. 6 Replace the front and side panels, and then close the computer. See "Opening and Closing the Computer" on page 1. 12 Upgrading and Servicing Guide - HP Presario SG3200 | Upgrade and Service Guide - Page 17
3 Disconnect the cable from the back of the memory card reader. 4 Pull the memory card reader out through the front of the chassis. Upgrading and Servicing Guide 13 - HP Presario SG3200 | Upgrade and Service Guide - Page 18
memory card reader partway into the front of the chassis. 4 Attach the data cable to the back of the memory card reader. 14 Upgrading and Servicing Guide - HP Presario SG3200 | Upgrade and Service Guide - Page 19
the open side panel. A - Connect to a primary hard disk drive. B - Connect to a secondary hard disk drive (select models only). C - Connect to the motherboard. Upgrading and Servicing Guide 15 - HP Presario SG3200 | Upgrade and Service Guide - Page 20
panel of the chassis. NOTE: If you are replacing an old drive with a new drive, remove the four guide screws from the old drive, and use them to install the new drive. If you are installing a second hard screws that secure the second hard disk drive to the chassis. 16 Upgrading and Servicing Guide - HP Presario SG3200 | Upgrade and Service Guide - Page 21
the connector out of the drive connector. Disconnecting the Serial ATA hard disk drive cables Disconnecting the Parallel ATA hard disk drive cables Upgrading and Servicing Guide 17 - HP Presario SG3200 | Upgrade and Service Guide - Page 22
access memory (RAM), which temporarily stores data and instructions on your computer. The computer is shipped with one to the Web site listed in your Limited Warranty and Support Guide, and click the Support link. WARNING: Using the wrong type of memory module . 18 Upgrading and Servicing Guide - HP Presario SG3200 | Upgrade and Service Guide - Page 23
, install the new module in the nearest memory socket to the preinstalled module, and then install additional modules in the next available sockets. Upgrading and Servicing Guide 19 - HP Presario SG3200 | Upgrade and Service Guide - Page 24
of the chassis, remove the screw from the bracket cover for the add-in card slots, and then remove the bracket cover. 20 Upgrading and Servicing Guide - HP Presario SG3200 | Upgrade and Service Guide - Page 25
are not replacing the old add-in card with a new add-in card, insert the metal slot cover into the open card slot. Upgrading and Servicing Guide 21 - HP Presario SG3200 | Upgrade and Service Guide - Page 26
. See "Opening and Closing the Computer" on page 1. NOTE: If the new add-in card or device does not work, read the card manufacturer's installation instructions and recheck all connections, including those to the card, power supply, keyboard, and monitor. 22 Upgrading and - HP Presario SG3200 | Upgrade and Service Guide - Page 27
a battery of the same, or an equivalent, type. Discard used batteries according to the manufacturer's instructions. 1 Prepare the computer to be opened, and then remove the side panel. See "Opening and the computer. See "Opening and Closing the Computer" on page 1. Upgrading and Servicing Guide 23 - HP Presario SG3200 | Upgrade and Service Guide - Page 28
Part number: 5992-1508
Upgrading and Servicing Guide