HP R/T3000 HP UPS R1500 G3 Installation Instructions
HP R/T3000 Manual
 |
View all HP R/T3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP R/T3000 manual content summary:
- HP R/T3000 | HP UPS R1500 G3 Installation Instructions - Page 1
HP UPS R1500 Generation 3 Installation Instructions Part Number 650952-001 - HP R/T3000 | HP UPS R1500 G3 Installation Instructions - Page 2
device, refer to the user guide for complete regulatory compliance notices. Kit contents • Important Safety Information guide • This document and/or documentation CD • HP Infrastructure Management Pack CD To download the latest software version, see the HP website (http://www.hp.com/go/rackandpower - HP R/T3000 | HP UPS R1500 G3 Installation Instructions - Page 3
in "Input specifications" in the user guide. Readying the equipment 1. Check the battery recharge date specified on the label that battery if the recharge date has passed. If the date on the battery recharge date label has passed without the battery being recharged, contact an HP authorized service - HP R/T3000 | HP UPS R1500 G3 Installation Instructions - Page 4
Before installing the unit, review and adhere to all batteries WARNING: The unit contains sealed lead-acid battery modules. To prevent fire or chemical burns: • Do not attempt to recharge batteries batteries. IMPORTANT: Before performing the following tasks, be sure that the unit is powered down - HP R/T3000 | HP UPS R1500 G3 Installation Instructions - Page 5
computer. IMPORTANT: Power management software requires the communications port to be appropriately cabled to the host computer. NOTE: An asterisk (*) indicates the default setting. For information about serial port pin assignment, see "Serial communications port pin assignment" in the user guide. - HP R/T3000 | HP UPS R1500 G3 Installation Instructions - Page 6
For more information about receptacle control, see "Power protector software" in the user guide. Charging the UPS batteries With the UPS in Standby mode, allow the batteries to charge before putting the UPS into service. IMPORTANT: Charge the batteries for at least 24 hours before supplying backup - HP R/T3000 | HP UPS R1500 G3 Installation Instructions - Page 7
Secure the UPS Network Module using the two screws you removed in step 1. 4. If the UPS is powered up, you can be sure that the UPS Network Module is seated properly and communicating with the UPS by verifying that the UPS Data LED illuminates solid green, and then flashes regularly after 2 minutes - HP R/T3000 | HP UPS R1500 G3 Installation Instructions - Page 8
to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
HP UPS R1500 Generation 3
Installation Instructions
Part Number 650952-001