HP RDX1000 Internal Removable Disk Backup System Plus 2RDX1000 HP StorageWorks
HP RDX1000 Internal Removable Disk Backup System Plus 2RDX1000 Manual
View all HP RDX1000 Internal Removable Disk Backup System Plus 2RDX1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP RDX1000 Internal Removable Disk Backup System Plus 2RDX1000 manual content summary:
- HP RDX1000 Internal Removable Disk Backup System Plus 2RDX1000 | HP StorageWorks - Page 1
connected to the system board. You can re-use the drive and cable with the HP StorageWorks RDX DL Server Module. 3. Remove the optical drive cage from the server, as instructed in the HP ProLiant Server User Guide. Retain the screws. 4. Install and route the supplied power and USB cables from the - HP RDX1000 Internal Removable Disk Backup System Plus 2RDX1000 | HP StorageWorks - Page 2
complete HP StorageWorks RDX DL Server Module. Follow the troubleshooting processes in the appropriate optical drive or RDX user guide. If there is an issue that requires replacement, follow the instructions below. If there is a problem with the optical drive, remove it and return for servicing. If
HP StorageWorks RDX DL Server Module
Installing the unit
HP StorageWorks RDX DL Server Module is an internal assembly for a Proliant DL server. It is
supplied with a USB and a power cable.
1.
Power down the server, remove the power cord and then remove the access panel.
2.
If an optical drive is already installed, remove it, leaving the SATA cable connected to the system
board. You can re-use the drive and cable with the HP StorageWorks RDX DL Server Module.
3.
Remove the optical drive cage from the server, as instructed in the HP ProLiant Server User Guide.
Retain the screws.
4.
Install and route the supplied
power and USB cables from the
server’s system board.
1 internal USB connector
2 power connector
3 SATA optical drive connector
(optional)
5.
Slide the HP StorageWorks RDX DL Server Module partially into the empty server bay.
6.
Connect the other end of the power
and USB cables to the connectors
on the rear of the HP StorageWorks
RDX DL Server Module.
1 USB connector
2 power connector
3 SATA optical drive connector
(optional)