HP T1500 IEC-320-C14 HP UPS R/T3000 G2 Installation Instructions
HP T1500 IEC-320-C14 Manual
 |
View all HP T1500 IEC-320-C14 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP T1500 IEC-320-C14 manual content summary:
- HP T1500 IEC-320-C14 | HP UPS R/T3000 G2 Installation Instructions - Page 1
with convertible tower design and offers power protection for loads up to a maximum of 3300 VA/3000 W (these numbers might vary by model). For more information about any of the topics covered in this document, see the UPS user guide located on the documentation CD or HP website (http://www.hp.com/go - HP T1500 IEC-320-C14 | HP UPS R/T3000 G2 Installation Instructions - Page 2
and one C13 extension bar. • The R/T3000 INTL model has an IEC-20-C19 input power receptacle specifications" in the user guide. Readying the equipment 1. , contact an HP authorized service representative for directions the same instructions as in "Installing the UPS ("Installing the UPS as a tower" on - HP T1500 IEC-320-C14 | HP UPS R/T3000 G2 Installation Instructions - Page 3
2. Insert screws through the rack into the mounting rail and the front of each mounting bracket. 5. Tighten the wing nuts or hex nuts. 3. Install cage nuts or clip nuts into the rear of the rack. 6. Install the rear stabilization bracket using wing nuts. Wait until the unit is installed and the - HP T1500 IEC-320-C14 | HP UPS R/T3000 G2 Installation Instructions - Page 4
Power Protector. NOTE: To install and configure the software, see the software user guide. The software user guide is available for download from the HP website (http://www.hp.com/go/rackandpower). Connecting the serial communications port CAUTION: Use only the computer interface cable supplied with - HP T1500 IEC-320-C14 | HP UPS R/T3000 G2 Installation Instructions - Page 5
attached to a single, normally-open contact in a parallel connection. HP recommends using different colors for the positive and negative wires. If in the user guide. For information about verifying the REPO connection, see "Verifying the REPO port connection" in the user guide. Connecting the ground - HP T1500 IEC-320-C14 | HP UPS R/T3000 G2 Installation Instructions - Page 6
by the selected output voltage to determine the VA. After verifying that the UPS will not overload the batteries to charge before putting the UPS into service. IMPORTANT: Charge the batteries for at least 24 is started. Installing the UPS as a tower Before installing the unit, review and adhere to - HP T1500 IEC-320-C14 | HP UPS R/T3000 G2 Installation Instructions - Page 7
Continuing the installation To continue the UPS installation, follow the instructions starting with "Connecting the serial communications port." Installing the extension bars (if included) Attaching the UPS front bezel Attaching the tower conversion stands WARNING: To reduce the risk of personal - HP T1500 IEC-320-C14 | HP UPS R/T3000 G2 Installation Instructions - Page 8
Connecting and securing the power cords 4. If the UPS is powered up, you can be sure that the UPS Network Module is seated properly and communicating with the UPS by verifying that the UPS Data LED illuminates solid green, and then flashes regularly after 2 minutes. Installing the optional UPS
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
HP UPS R/T3000 G2
Installation Instructions
Overview
The HP UPS R/T3000 G2 features a 2U rack-mount with convertible
tower design and offers power protection for loads up to a maximum of
3300 VA/3000 W (these numbers might vary by model).
For more information about any of the topics covered in this document,
see the UPS user guide located on the documentation CD or HP website
Precautions
WARNING:
To prevent personal injury from earth
conductor leakage current:
•
Do not operate the UPS while disconnected from the
utility power source.
•
Disconnect load devices before disconnecting the UPS
from the utility power source.
37 kg
82 lb
This symbol indicates that the UPS exceeds the
recommended weight for one individual to
handle safely.
WARNING:
To reduce the risk of personal injury
or damage to the equipment, observe local
occupational health and safety requirements and
guidelines for manual material handling.
Kit contents
•
Important Safety Information
guide
•
This document and/or documentation CD
•
HP Infrastructure Management Pack CD
To download the latest software version, see the HP website
•
Warranty information
•
Rails, with mounting hardware
•
Tower conversion stand (2)
•
Front mounting ears (2) and associated hardware
© Copyright 2011 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The only
warranties for HP products and services are set forth in the express warranty
statements accompanying such products and services. Nothing herein should
be construed as constituting an additional warranty. HP shall not be liable for
technical or editorial errors or omissions contained herein.
Part Number: 650953-001
January 2011
Edition: 1