HP Workstation x2000 3Dlabs Wildcat III 6110 graphics accelerator card (read b
HP Workstation x2000 Manual
View all HP Workstation x2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Workstation x2000 manual content summary:
- HP Workstation x2000 | 3Dlabs Wildcat III 6110 graphics accelerator card (read b - Page 1
HP Product No. A8051A General HP Installation Instructions NOTE Before you install your graphics card, refer to the your workstation's Technical Reference (www.hp . The chipset driver can be downloaded from http://www.hp.com/go/workstationsupport. 1. Before opening your workstation to install the - HP Workstation x2000 | 3Dlabs Wildcat III 6110 graphics accelerator card (read b - Page 2
driver upgrades and the Card Installation Instructions as supplied by 3Dlabs go to: http://www.hp driver from the provided CD-ROM. 5. Refer to your workstation's Owner's Guide for instructions . The type of service provided is return to an HP or repair-authorized reseller service-center. At Hewlett- - HP Workstation x2000 | 3Dlabs Wildcat III 6110 graphics accelerator card (read b - Page 3
. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference - HP Workstation x2000 | 3Dlabs Wildcat III 6110 graphics accelerator card (read b - Page 4
to ISO/IEC Guide 22 and EN 93/68/EEC This product was tested in a typical Hewlett-Packard workstation configuration. Original signed by Ruth Lutes, Site Quality Manager, Fort contact: European Contact: Your local Hewlett-Packard Sales and Service Office or Hewlett-Packard GmbH, Dept. HQTRE Standards
Hewlett-Packard Company
3404 East Harmony Road
Fort Collins, Colorado 80528
Read Before Installing
3DLabs Wildcat III 6110 Graphics Accelerator Card
HP Product No. A8051A
General HP Installation Instructions
NOTE
Before you install your graphics card, refer to the your workstation’s
Technical
Reference
(
www.hp.com/go/workstationsupport
) for important system
configuration information.
CAUTION
Graphic cards are susceptible to electrostatic shock. When handling your card
always wear a properly grounded wrist strap and handle the card carefully.
The latest workstation BIOS must be installed on your workstation
before
installing the new graphics card. The latest BIOS can be downloaded from
http://www.hp.com/go/workstationsupport. If the latest BIOS is not installed, you
may experience no video, PCI Option ROM errors and system stops during self-
test (POST).
In addition, if you have purchased and/or installed Windows
®
2000, a chipset
driver must be installed to enable AGP. If an AGP graphics card is not run in
AGP mode, you may experience extremely slow graphics performance, system
lockups and Windows
®
stop errors. The chipset driver can be downloaded from
1.
Before opening your w
orkstation to install the graphics card, disconnect all cables from the system. When refer-
ring to your system model/type and for obtaining the proper driver version, please use the AxxxxX nomenclature
found on the Serial Number plate on the back of the machine.
2.
Following the procedures described in your workstation’s
Technical Reference
, install the graphics board into the
AGP Pro slot (see the next diagram). Slide the board into the slot and ensure it is fully seated in the connector.
3.
Attach your monitor cable to the primary port. If you have two monitors, attach the primary monitor to the pri-
mary port and the second monitor to the secondary port. Use the included DVI-I dongle to attach an analog mon-
itor to the either port.