HP Xw8400 Front fan kit installation
HP Xw8400 - Workstation - 4 GB RAM Manual
 |
UPC - 883585271085
View all HP Xw8400 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Xw8400 manual content summary:
- HP Xw8400 | Front fan kit installation - Page 1
provides extra cooling for high power PCI cards. Kit contents The kit for your workstation includes the following components: ■ Front fan ■ Installation instructions ■ Warranty Before you begin See http://www.hp.com/accessories/workstations to determine the compatibility of this product with your - HP Xw8400 | Front fan kit installation - Page 2
, including powering down the workstation, disconnecting power from the workstation, opening the access panel, and removing components. For product-specific information, refer to the Service and Technical Reference Guide for your HP workstation at http://www.hp.com/support/workstation_manuals - HP Xw8400 | Front fan kit installation - Page 3
card guide toward the system board 1 and lift it out of the chassis 2. (The following figures show an HP xw8400 Workstation for reference.) Figure 1 Remove card guide 2. Attach the front fan to the card guide. Place the fan in the card guide with the fan label facing into the card guide, and the fan - HP Xw8400 | Front fan kit installation - Page 4
3 Install front fan/card guide assembly in chassis Step 3-Reassemble the workstation After installing the front fan/card assembly, reassemble the workstation using the instructions in the workstation documentation. Reassembly involves reinstalling the side access panel and restoring power to the - HP Xw8400 | Front fan kit installation - Page 5
HP Workstation PCI HP Workstation http://www.hp.com/accessories/workstations PCI PCI 5/8 - HP Xw8400 | Front fan kit installation - Page 6
Å Å Safety & Comfort Guide http://www.hp.com/ergo CD HP HP Workstation 1 http://h50146.www5.hp.com/doc/manual/workstation/hp_workstation.html HP Workstation 6/8 - HP Xw8400 | Front fan kit installation - Page 7
2 1 2 1 2 HP xw8400 Workstation 図 1 2 図 2 7/8 - HP Xw8400 | Front fan kit installation - Page 8
3 1 2 3 3 図 3 3 416481-002 © 2006 Hewlett-Packard Development Company, L.P. The HP Invent logo is a registered trademark of Hewlett-Packard Development Company, L.P. 8/8
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
1/8
Front fan kit installation
Front fan kit installation
This document describes how to install a front fan in an HP workstation. The front fan provides extra
cooling for high power PCI cards.
Kit contents
The kit for your workstation includes the following components:
■
Front fan
■
Installation instructions
■
Warranty
Before you begin
See
to determine the compatibility of this product with
your HP workstation.
✎
This optional front chassis fan is recommended only if it is required for non-factory-integrated high power
PCI cards. When this fan is installed, HP recommends that you verify that the temperatures of the PCI card
and other components are within the limits recommended by the component suppliers.
Observe warnings and cautions
Å
WARNING:
Any surface or area of the equipment marked with these symbols indicates the presence of
a hot surface or hot component. If this surface is contacted, the potential for injury exists. To reduce the
risk of injury from a hot component, allow the surface to cool before touching.
Å
WARNING:
Any surface or area of the equipment marked with these symbols indicates the presence of
an electrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed
area.