HP xw4000 HP xw and Z Series Workstations - Installing an HP Solenoid Lock and
HP xw4000 Manual
View all HP xw4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP xw4000 manual content summary:
- HP xw4000 | HP xw and Z Series Workstations - Installing an HP Solenoid Lock and - Page 1
Sensor in HP Workstations Installations in HP Workstations, such as the HP Z600 Workstation series, may be different. Complete installation and removal procedures for this product are included in the service guide for your workstation model, available at http://www.hp.com/support/manuals. © 2004 - HP xw4000 | HP xw and Z Series Workstations - Installing an HP Solenoid Lock and - Page 2
proper computer setup, posture, health, and work habits for computer users, and provides important electrical and mechanical safety information. This guide is located at http://www.hp.com/ergo and on the documentation CD (if one is included with the product). WARNING! If a product is shipped in - HP xw4000 | HP xw and Z Series Workstations - Installing an HP Solenoid Lock and - Page 3
the Hood Sensor NOTE: Computer models vary, and all illustrations are examples only. For product-specific information, see the service guide for your HP computer at http://www.hp.com/support/manuals before beginning installation. The attachment point for the Hood Sensor may be located on the front - HP xw4000 | HP xw and Z Series Workstations - Installing an HP Solenoid Lock and - Page 4
with other system board connectors or computer components. NOTE: To locate system components on HP Workstations, see the service label on the side access panel. On some HP Workstations, such as the HP Z600 Workstation series, the Solenoid Lock cable does not connect to the system board. Figure - HP xw4000 | HP xw and Z Series Workstations - Installing an HP Solenoid Lock and - Page 5
> Save Changes and Exit. Remote security management It is possible to remotely lock and unlock the Solenoid Lock using Remote Access Software. Refer to www.hp.com/go/hpcmi for tools you can use to remotely manage the computer and - HP xw4000 | HP xw and Z Series Workstations - Installing an HP Solenoid Lock and - Page 6
panel to access the internal components of the computer. 6. Unplug the Solenoid Lock cable from the system board and remove the lock assembly. 6 Installing an HP Solenoid Lock and Hood Sensor ENWW
Installing an HP Solenoid Lock and Hood
Sensor
Introduction
The side access panel Solenoid Lock is designed to prevent unauthorized removal of the computer
cover. The side access panel may be locked by using a local or remote signal-controlled solenoid.
The Hood Sensor is designed to notify the user of any removal of the computer cover.
Kit contents
●
Solenoid Lock assembly, including solenoid, bracket, and cable
●
Two tamper-resistant screws
●
Solenoid Lock FailSafe Key
●
Sensor and power cable
●
Sensor bracket
●
Two sensor bracket screws
●
Warranty information
●
This installation guide
Before you begin
To determine the compatibility of this product with your HP computer, see
QuickSpecs
online at
go/productbulletin
.
Installing the Solenoid Lock and Hood Sensor in HP Workstations
Installations in HP Workstations, such as the HP Z600 Workstation series, may be different.
Complete installation and removal procedures for this product are included in the service guide for
your workstation model, available at
support/manuals
.
© 2004–2010 Hewlett-Packard Development Company, L.P. Printed in the U.S.
ENWW
Introduction
1