Humax DVR-9900C User Manual - Page 73

14. Universal Remote Control 14. Universal Remote Control 14.1 Universal Setup for Operation with TV Unit The universal remote control also allows you to operate the most important functions, such as the volume, on your TV. To be able to use this universal functionality, you must perform a one-time setup of the TV. The following describes the steps required to set up your TV: 1. Preparing the TV 1. Switch your TV on. 2. In the list of codes at the end of these instructions, search for the 4-digit code number given for the manufacturer of your TV. If you are unable to find the manufacturer of your TV in the list, use the code number '0000'. ** 2. Programming the universal remote control 1. Press the TV and Liste button on the receiver remote control at the same time. Keep both buttons pressed for 5 seconds until the TV LED (a small red lamp at the top of the remote control) blinks twice. 2. Enter the 4-digit code number for your TV using the NUMERIC(0-9) buttons on your receiver remote control. The TV LED is now permanently lit. 3. Then press the STANDBY button. Keep the STANDBY button pressed until the TV switches off. Release the STANDBY button as soon as the TV has switched off. Note: This process can take several minutes, in some cases up to 15 minutes. During this time, the remote control sends all possible TV signals one after another. Each time a signal is sent by the remote control, the TV LED briefly extinguishes. GB 72