Humax F1-CI User Manual - Page 5

STB Connection Introduction There are several ways of connecting the STB to your existing TV/Audio system. Some of the methods enable you to listen to music in stereo sound of CD like quality. Consult your local supplier for assistance in setting up an Video/Audio configuration best suited to your unique requirements. Hints to Quality TV System Configurations q Connect cables via Audio/Video Outputs/Inputs or SCART connector instead of RF connectors, where possible. q Use an appropriate, correctly installed antenna system. q Ensure that the system is properly earthed and protected against lightning. q Connect the STB to high quality stereo TV and Hi-Fi equipment. Note : When Video/Audio Input Outputs or SCART connector are available a "Video" mode may need to be selected in place of a "TV" mode on the VCR and the TV. Connection 1. Switch off the mains supply in the STB before connecting or disconnecting the LNB. Connect the TV antenna connector into the RF IN socket on the STB. 2. Use the flylead supplied with the STB to connect the RF OUT socket on the STB to the RF IN (aerial) connector on the VCR. 3. Use the flylead supplied with the VCR to connect the RF OUT socket on the VCR to the RF IN (aerial) connector on the TV. 4. Connect the coaxial cable from the LNB into the socket marked LNB IN on the STB. The connector on the LNB IN should be turned until it is finger tight. 5. Connect the power plug of the STB into the mains wall socket and switch the power on. Note : As the SCPC channel is a weak signal it is important that the satellite dish is installed precisely to receive it, or moving pictures may be displayed with picture break up errors. 2 SATELLITE DISH TV SCART RF IN LNB IN LNB OUT CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN 0/12V OUT 50mA RS-232 TV SCART VCR SCART VCR SCART RF OUT RF IN TV ANTENNA VIDEO R AUDIO L RF OUT RF IN Max. power consumption : 35 W Power supply : 230V 50Hz POWER CAUTION DISCONNECT THE IRD FROM THE MAINS BEFORE CONNECTING OR DISCONNECTING THE LNB.