Humax F2-1001T User Manual - Page 13

2. Setup ** This chapter describes how to set up the receiver. Select the most appropriate procedure depending on your case. Note: If you encounter any problem when setting up the receiver, please contact your local product distributor. 2.1 Connecting Aerial 1. Connecting TV and VCR ** • Connect the cable of your TV aerial to the ANTENNA IN connector on the rear of the receiver. • Scart and co-axial cable are connected as in the figure above. 2.2 Powering On 1. Connect the power cord of the receiver to a wall outlet. 2. Power on by pressing the STANDBY button at Remote Controller. The Standby LED indicator is turned on Green. GB 12