Humax HD-5600S User Manual - Page 63

Installation Search Channels [SCD Antenna] MENU Settings Installation Search Channels Single Cable Distribution enables the delivery of broadcast programming over a single cable to multiple users eliminating the numerous cables required to support other electronics devices. If you are using more than one satellite receiver, set one receiver at a time and turn off the others while setting. Refer to the satellite antenna manual for details. 1. Check that your antenna connection and the selected antenna type are correct. 2. Select SCD Setting and press the OK button to set the channel(band) and frequency for this receiver. Tuner1: Select from Channel 1~8. Frequency: The frequency is set based on the channel of tuner1. 3. Select OK. 4. Select a satellite figure and press the OK button. Satellite: Select the satellite. LNB Frequency: Select the LNB frequency. 22Khz Tone : Select On or Off. Test Transponder: Check the signal status of each transponder and select the one with the best quality. 5. Select OK. 6. Select Transponder under the activated satellite figure and press the OK button. 7. Select a value in the transponder list. 8. Repeat the four steps above to set more satellites. 9. Select Search and press the OK button. The found channels will be listed. 10. When the search has completed, select Save and press the OK button to save the found channels. Note: • Select User Define to enter options directly. • Select Stop and press the OK button to stop the channel search. • Refer to Setting Transponder for details in transponder setting. Menu On/Off 62 Select Confirm Enter 0~9