Humax IR-ACE User Manual - Page 50

3. Initial Satellite Position Search This is required when you first set your receiver up to use DiSEqC 1.2, and sets the positions of all pre-programmed satellites. 1. Make sure your motor is installed correctly with the calibrations adjusted for the region in which you are located. (Please consult the user's manual for your motor). 2. Make sure your receiver is set up to use DiSEqC 1.2. (see Section 2 above). 3. In the Main menu, select the Service Searching option and press the OK ( ) button. You should now see the Service Searching menu. 4. Highlight the Alternative Antenna option and press the OK ( ) button to display the Satellite Setting menu. 5. Highlight the DiSEqC Command Mode option and use the buttons to change the value to Installer, then press the OK ( ) button. 6. Highlight the Motor Control option and use the buttons to change the value to reset, then press the OK ( ) button. 7. You will now see a warning message. Press the OK ( ) button to continue. All the pre- programmed satellite motor positions should now be correct. If you have any other DiSEqC 1.2 motor brand or model, then you may need to store the satellite positions yourself. (Please refer to the user's manual for your motor). 8. Highlight the DiSEqC Command Mode option and use the buttons to change the value to User, then press the OK ( ) button. 9. You should now be ready to start storing services for the various satellites (see 5 onwards). 4. Motor Limit Setting Use this option to set the East and West limits of the motor. This should be used to prevent your dish from hitting anything that may obstruct the path of the dish. 1. On the Main menu, select the Service Searching option and press the OK ( ) button. You should now see the Service Searching menu. 2. Select the Manual Search option and press the OK ( ) button. You should now see the Manual Search menu. 3. Highlight the Alternative Antenna option and press the OK ( ) button. You should now be in the Satellite Settings menu. 4. Press the RED button to access the Motor Limit Setting menu. 5. Highlight the Limit Setting option and use the buttons to disable this. (Warning: When this option is disabled, your motor will be able to move beyond any limits previously stored - please make sure there is nothing obstructing the path of your dish.) GB49