Humax PVR-8000T User Manual - Page 16
Installation Wizard - reset
View all Humax PVR-8000T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
3. Installation Wizard ** This will guide you through the installation procedure and will perform an channel search automatically. (Installation Wizard will also run after the receiver has been returned to Default Settings.) ** Search ** Please wait until the channel search is complete. 1. During the channel search, the cursor is located at Stop. Therefore, if you press the OK button during searching, the operation is stopped and the channels found until then will be displayed. 2. Even if the search does not find any channels, press the OK button and try to reset the search operation again if necessary. 3. You can delete unwanted channels from the found channels. Select your desired channels to delete and press the OK button. Then select Delete and press the OK button. To delete all channels, select Select All to select all channels, select Delete, and press the OK button. 4. After completing the Channel Search and deleting unwanted channels, select Save to save the changes. Warning: If you exit the Install Wizard without fully completing the channel searching procedures, you many not receive all the channels available. In this case, you can use the Installation Menu to configure your receiver as you like. GB 15